Bedienungsanleitung Severin ht 0111 (Seite 9 von 46) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

399093

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Hair dryer

Dear Customer

Before using the appliance, the user should

read the following instructions carefully.

Connection to the mains supply

The hair dryer should only be connected to a

socket installed in accordance with the

regulations.

Make sure that the supply voltage corresponds

with the voltage marked on the rating label of

the hair dryer.

This product complies with all binding CE

labelling directives.

Familiarisation

1. Air intake opening

2. Hanging loop

3. Flexible non-kink covering

4. Power cord with plug

5. Air intake grille release button

6. Air flow control

7. Air temperature control

8. Cool function

9. Styling nozzle

10. Air outlet opening

Important safety instructions

■ Caution: do not use the

appliance in the vicinity of a

bath, shower or swimming-

pool, over a washbasin filled

with water or near any other receptacle

containing water.

Protect the appliance from moisture and

splashing water and do not operate it with

wet hands.

■ In the vicinity of any water source, there is

a risk even when the appliance is switched

off. Therefore, always remove the plug from

the wall socket after use, especially if the

appliance is being used in a bathroom.

For additional protection, the installation of

a residual current device (RCD) having a

rated residual operating current not

exceeding 30 mA is advisable in the

electrical circuit supplying the bathroom.

Ask your installer for advice.

■ Electric heating appliances operate at very

high temperatures. Do not touch any part of

the appliance except the grip. Otherwise

there is a real risk of burning.

■ Do not use the appliance on synthetic hair-

pieces or wigs, as the heat emitted might

cause damage to the synthetic fibres.

■ Make sure the air intake and outlet

openings are not blocked (e.g. by fingers or

hair), and that no fluff or fibre particles are

allowed to accumulate in the air intake.

A blockage in the air-flow system may

cause the integral thermal safety cut-out to

switch off the appliance. Should this occur,

immediately disconnect the appliance from

the mains power and allow sufficient time

for it to cool down before the blockage is

removed and the appliance is switched on

again.

■ Every time the appliance is used, the main

body including the power cord as well as

any attachment fitted should be checked

thoroughly for any defects. Should the

appliance, for instance, have been dropped

onto a hard surface, it must no longer be

used: even invisible damage may have

adverse effects on the operational safety of

the appliance.

■ To prevent damage to the power cord,

- do not bend or kink the cable, especially

where it leaves the housing,

- do not pull on the cord,

- do not coil the power cord around the

appliance.

■ Do not leave the appliance unattended

while in use.

■ Always switch off and remove the

plug from the wall socket after use,

as well as

- in cases of malfunction, and

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin ht 0111 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info