these instructions are not complied with.
In order to comply with safety regulations z
and to avoid hazards, repairs of electrical
appliances must be carried out by quali ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. e
addresses can be found in the appendix to
this manual.
Before using for the rst time
Before making co ee for the rst time, let the
appliance go through two or three ltration
cycles using the indicated maximum amount
of cold water, but without using ground co ee.
is should also be done if the appliance has
not been used for an extended period of time,
and a er descaling.
General information
A measuring scale on the water container –
facilitates lling the container with the
correct amount of clean water. With a
dual-scale, the le scale is used for regular-
sized cups of approx.125ml, while the right
scale is used for smaller cups. Make sure
that the indicated maximum amount of
water is not exceeded.
If several consecutive brewing cycles are z
required, let the appliance cool down for
approx. 5 minutes a er each cycle.
Important note: z When lling the
appliance with fresh water shortly a er
a brewing cycle is completed, there is
a danger of scalding from hot water or
steam escaping through the water outlet.
Making co ee
Filling with water: –
Open the lid and ll the container with the
desired quantity of water.
Inserting the paper lter: –
Open the swing-out lter and insert a size-4
paper lter into the lter holder, rst folding
down the perforated sides of the lter.
Filling with ground co ee: –
For each regular-sized cup (125ml), a measure
of about 6 g (= 1½ - 2 teaspoons) of medium
or nely ground co ee will be required. Close
the swing-out lter a erwards, ensuring that
it locks into place.
Preparing the glass carafe: –
Place the drip-through lid onto the carafe and
close it. Ensure that the two arrow marks on lid
and carafe are properly aligned before placing
the carafe into the appliance. If correctly
inserted, the lid will disable the drip-stop
mechanism in the lter holder during the
brewing cycle.
Starting the brewing cycle: –
Insert the plug into a suitable wall outlet
and use the Start button to switch the co ee
maker on. e ltration cycle starts and the
water passes through the lter. e LED
indicator lamp lights up.
Removing the glass carafe: –
Wait until all the water has passed through
the lter before the carafe is removed from the
appliance. Once the brewing cycle is complete,
the appliance switches o automatically and
the LED indicator lamp goes out. To interrupt
the brewing cycle, disconnect the appliance
from the mains.
Switching o the co ee maker: –
Remove the plug from the wall outlet a er
use.
Heat-retaining carafe
For technical reasons the screw-in lid does –
not close hermetically. erefore always
hold the carafe in an upright position when
lled with co ee.
Keeping the co ee hot – : A heat-conserving
carafe accumulates heat energy. erefore
the carafe should preferably be lled to
its maximum capacity. If it is only partly
lled, the temperature will not be held as
e ciently. If you rinse out the carafe with
hot water before use, the co ee will be kept
warm for a longer time.
During brewing, and also while pouring –
the co ee from the heat-retaining carafe,
the drip-through lid does not need to
be removed and should remain in place.
To pour the co ee, turn the lid counter-
9
