Bedienungsanleitung Severin KA 5990 (Seite 10 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

544459

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

the power cord. If repairs are needed, please send the

appliance to one of our customer service departments. The

addresses can be found in the appendix to this manual.

On/Off switch with temperature indicator light

The red temperature indicator light remains lit while the

appliance is switched on. It ﬂ ashes while the unit is pre-heating.

Rotary control

The rotary control has four settings:

Dispensing steam/hot water via the steam tube

Heating up for hot-water/steam

Neutral position / unit in standby-mode

Drawing espresso

Caution: As soon as the rotary control is turned to the steam or

espresso symbol, steam or hot water will be emitted.

Hot-water/steam selector button

With the rotary control in the ‘Heating-up’ ( ) position, the

selector button can be used to select either hot water or steam.

Hot water or steam may then be drawn from the hot-water/

steam nozzle.

∙ When drawing hot water, the symbol is lit (default

setting).

∙ When dispensing steam, the symbol lights up.

Inserting/removing the ﬁ lter sieve holder:

∙ The ﬁ lter sieve holder is ﬁ tted to the appliance by means of a

bayonet-type locking socket. When attaching it, the handle

must be facing to the left of the boiler outlet (picture I). To

lock, turn the holder ﬁ rmly as far as possible to the right

(picture II).

∙ To unlock and remove the holder, turn it to the left.

∙ Caution: Do not remove the sieve holder while the

appliance is in use, since the holder is under pressure. Once

the brewing cycle is complete, wait around 30 seconds before

removing the sieve holder.

Filling with water:

∙ Fill only with fresh water, on a daily basis; make sure that

the water container is cleaned at regular intervals. Residual

water should be poured out daily. Do not switch the

appliance on unless the water container is ﬁ lled.

∙ Lift out the water container before it is ﬁ lled.

∙ Fill the container with (non-carbonated) cold water while

observing the ‘Max’ marking on the water container.

∙ Once ﬁ lled, replace the container in the appliance and

push it down.

∙ Close the lid on the water container.

∙ The water level must be monitored and, if necessary, the

container reﬁ lled in good time.

Please note:

Should the pump have started sucking in air from the

empty water container, ﬁ ll the water container ﬁ rst

with the indicated maximum amount of water. When

‘bleeding’ the system afterwards, it may take a few

moments before water is emitted again.

∙ Deposits of dirt and lime may cause the seals in the outlet

at the bottom of the water container and those around

the valves to leak. Check the seals carefully each time

the water container is inserted and, if necessary, carefully

remove any existing deposits.

Automatic switch-off

If the unit is not used for a period of 90 minutes, it will switch off

automatically to save power.

Before using for the ﬁ rst time

∙ Before the appliance is used for the ﬁ rst time, all detachable

parts must be thoroughly cleaned as described in the

section General Care and Cleaning. Reﬁ t all parts

afterwards.

∙ Clean the system by ﬂ ushing with water as follows:

∙ Fill the container with water up to its ‘Max’ mark.

∙ Insert the sieve holder with either sieve in place, but

without any ground coffee.

∙ Place a suitable container, with a capacity of about 1000

ml, underneath the outlet openings.

∙ Insert the plug into a wall outlet.

∙ Use the On/Off switch to turn the appliance on. The unit

heats up. Once the temperature indicator light shows

steady, turn the rotary control to position

. Hot water is

now emitted from the sieve holder outlets.

∙ Stop the process once the water container is about half

full. Always empty the receptacle under the outlets in good

time.

∙ Empty the receptacle. Use the insulated ring grip to pull

the steam tube forward. Place the receptacle under the

steam tube.

∙ Turn the rotary control to the ‘Heating up’ position ( ).

∙ The hot-water indicator on the selector button ( ) lights

up.

∙ Turn the rotary control to the ‘Water/Steam’ position ( ).

∙ Water is now emitted through the hot-water/steam nozzle.

∙ Stop the process by turning the rotary control to position

( ) before the container is completely empty.

Please note:

This cleaning procedure should also be followed if the

appliance has not been used for an extended period of time.

General operation

Good espresso is characterised by its hazelnut-brown, thick

crema. It is made from dark-roasted, especially ﬁ ne-ground

coffee beans. A quantity of 20-35 ml per cup should not be

exceeded. You are recommended to use thick-walled and

preheated cups for espresso.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KA 5990 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info