Bedienungsanleitung Severin KA 5993 (Seite 14 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

544461

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

turning the rotary control to its neutral

position ( ).

∙ This cleaning procedure should also be

followed if the appliance has not been

used for an extended period of time.

Operation

General

Espresso is a strong coffee with its typical

froth, the ‘crema’, made from dark-roasted

coffee beans. Especially ﬁ nely ground coffee

is necessary to make espresso.

∙ Preheating the cups and the ﬁ lter

holder

We recommend pre-heating the cups

and the ﬁ lter holder, as this will ensure a

higher coffee temperature.

∙ Insert the appropriate ﬁ lter sieve for the

amount of espresso required into the

ﬁ lter holder and push it ﬁ rmly down until

it is heard locking into place.

∙ Fit the ﬁ lter holder to the appliance and

place a cup underneath it.

∙ As soon as the operating temperature

has been reached, the temperature

indicator light comes on.

∙ Turn the rotary control to the

symbol.

∙ When the cup is about three quarters

full, turn the rotary control to its neutral

position to switch off the pump.

∙ Put the cup aside to warm up; pour out

the water just before making espresso.

∙ Filling the ﬁ lter sieve with ground

espresso coffee / removing the

espresso grounds

Filling with ground espresso coffee

∙ Remove the preheated ﬁ lter holder

(Caution: the ﬁ lter holder will be very

hot). Pour out any residual water.

∙ Fill with ﬁ nely ground espresso coffee:

∙ single espresso = 1 level measuring

scoop

∙ double espresso = 2 level measuring

scoops

Note: if the ﬁ lter holder is over-ﬁ lled, it

will not lock properly under the boiler

outlet. Do not put in more than the

quantity indicated above.

∙ Use the measuring scoop to distribute

the ground espresso coffee evenly and

press it down lightly. Any excess coffee

powder on the rim of the ﬁ lter holder

must be removed.

Removing the used grounds

∙ After the brewing cycle is complete,

wait approximately 30 seconds until the

operating pressure has been sufﬁ ciently

reduced.

∙ Exercise caution when removing the

ﬁ lter holder: it may still contain some hot

water. Pour out the water carefully.

∙ Allow the ﬁ lter holder to cool down

sufﬁ ciently before tapping its side against

a vertical surface to loosen the grounds

before emptying it.

∙ The cut-outs on the ﬁ lter holder facilitate

removing the ﬁ lter sieve; use the ﬁ ngers

to pull the sieve out from above. Clean

the ﬁ lter holder and sieve thoroughly.

∙ Filter sieve - inserting and removing

espresso pads

Inserting the espresso pad:

∙ Remove the pre-heated ﬁ lter holder

with the ﬁ lter sieve (Caution: the ﬁ lter

holder will be very hot). Pour out any

residual water.

∙ Insert an espresso pad into ﬁ lter sieve

‘c’ (pad sieve). Ensure that the paper

rim of the ESE pad does not protrude

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KA 5993 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info