Bedienungsanleitung Severin KS 9704 (Seite 18 von 124) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712683

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

∙ Take care not to remove or damage the rating plate inside

the cabinet during cleaning.

De-frosting the freezer compartment

∙ After a certain period of operation and depending on several

factors (e.g. how often the door has been opened), a layer

of ice will form on the evaporators located below the drawers

and on the drawer fronts themselves. Once the build-up

of ice has reached a thickness of 3 to 5 mm, the unit must

be de-frosted, as the build-up of ice increases the power

consumption of the appliance.

∙ The freezer should be thoroughly cleaned at least twice a

year.

∙ Always remove the plug from the wall socket before

cleaning.

∙ Remove all food from the compartment and store it in a

cool location, eg together with pre-frozen freezer-packs

in a closed plastic container. Note that, even with a slight

increase in temperature, the storage life will be shortened

and the food should be used as soon as possible.

∙ Keep the door open.

∙ Remove the cover panel.

∙ Pull out the drain channel from the freezer cabinet, turn it

180° and secure it (see diagram). Place a suitable container

underneath the channel outlet.

∙ To accelerate defrosting, one or several containers with

hot (but not boiling) water may be placed inside the freezer

compartment. Do not pour water over or inside the unit.

∙ Warning: Do not use any external device or other means

(e.g. heaters or heating fans) to accelerate de-frosting.

∙ Clean the unit with a damp cloth and a little detergent. Wipe

thoroughly dry afterwards.

∙ Replace the drain channel and cover panel.

∙ Set the temperature control to its maximum position. After 24

hours, it may turned back to its normal setting.

Defrosting the refrigerator cabinet :

∙ The refrigerator cabinet does not require de-frosting, but

only proper cleaning.

∙ The integral vapouriser is sealed in foam in the rear wall;

you may therefore notice a build-up of frost around the

rear area. This layer of frost will start melting when the

compressor is not working. Through a system of hoses,

the melt-water drains into the collection tray below the

compressor, where it will be absorbed into the surrounding

air.

∙ To enable the melt-water to drain freely, always ensure that

the channel and discharge opening in the cabinet are free of

any blockage.

∙ Any water collecting in the bottom should be removed.

Energy saving tips

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers etc.).

If this cannot be avoided, however, suitable insulation must be

installed between the heat source and the unit.

∙ Ensure sufﬁ cient air circulation around the sides of the unit.

∙ The compressor (at the rear) should be cleaned at regular

intervals. Accumulated dust causes an increase in energy

consumption.

∙ Warm food should be

allowed to cool down

before it is stored inside.

∙ To prevent an increased

build-up of ice, do not

leave the doors of the

unit open for too long

when loading or taking out food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to the

section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For detailed

information on the temperature settings, please refer to the

section Temperature control.

Operating noise

∙ Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the electrical motor within the compressor

assembly; during compressor start-up the sound level will

be slightly higher for a limited period of time.

∙ caused by the cooling agent ﬂ owing through the circuit.

Trouble-shooting

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

p roblems, check ﬁ rst whether a solution can be found using this

table. If the problem persists, disconnect the appliance from the

mains power and contact our Customer Service Department.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9704 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info