Bedienungsanleitung Severin KS 9816 (Seite 16 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712710

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

∙ To prevent an increased build-up of ice, do not leave the

freezer door open for too long when loading or taking out

food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to the

section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For

detailed information on the temperature settings, please

refer to the section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the

electrical motor within

the compressor

assembly; during

compressor start-up

the sound level will be

slightly higher for a

limited period of time.

∙ caused by the cooling agent ﬂ owing through the circuit.

The following table lists the possible malfunctions, their

probable causes and solutions. In the event of operational

problems, c heck ﬁ rst whether a solution can be found using

this table. If the problem persists, disconnect the appliance

from the mains power and contact our Customer Service

Department.

Problem Possible cause and solution

The unit is not working.

Check that

∙ the switch in your home installation fuse box is switched on.

∙ the wall socket is working. This can be done by connecting another electrical device to

the socket and checking for function.

The unit seems to generate

insufﬁ cient cooling power.

Check whether

∙ too much food has been stored in the unit.

∙ the thermostat is set to position ‘COLD’ (in this case, set it to a suitable higher value).

∙ the door is not properly closed.

∙ there is too much dust on the condenser.

∙ the unit is too close to a wall or other object at the rear or to the sides.

The normal operating sound

changes or becomes louder.

Check whether

∙ the unit has been properly positioned.

∙ any objects or obstructions are touching the rear of the unit.

∙ there are any objects on top of the unit which might be vibrating.

Transporting the appliance

To prevent damage to the unit during transport, ensure that

all accessories and components inside and around the

appliance are securely fastened.

The unit must only be transported in its vertical position; do

not tilt any more than 30°.

Once the unit has been positioned, wait for about 30

minutes before it is connected to the mains.

If the unit has been tilted more than 30° during transport,

allow it to stand in an upright position for at least 4 hours

before it is connected to the mains.

Disposal

This appliance has been manufactured from

recyclable materials. After removing the plug from

the wall socket, the unit should be rendered

unusable by cutting off the power cord before

being disposed of through special waste collection points in

accordance with local regulations. The refrigerant and the

chemical agent in the insulation foam must be disposed of

through a competent agency. Take special care not to

damage the cooling circuit before the unit is handed over for

competent disposal.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9816 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info