Bedienungsanleitung Severin KS 9878 (Seite 11 von 72) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

603081

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Ventilation

The heated air around the rear of the unit must be able to

circulate freely. Therefore, ensure that the air circulation is not

obstructed.

Warning: Take special care that the ventilation openings

in the upper part of the rear panel are not blocked or

obstructed.

Temperature control

∙ The unit is activated by connecting it to the mains. It is only

switched off completely when the plug is removed from the

wall socket.

∙ The green mains indicator light shows that the unit is

connected to the mains.

∙ The temperature in the refrigerator cabinet can be adjusted

by setting the temperature control (1-5). Turning the control

clockwise will decrease the temperature, while turning it anti-

clockwise will increase it.

∙ The temperature can be set within a 0 to 10°C range.

∙ The temperature in the cabinet largely depends on factors

such as the ambient temperature, the setting and the

number of bottles stored.

∙ We recommend using a thermometer to check the actual

temperature inside the cabinet and make adjustments as

necessary.

∙ Always ensure that the door is properly closed and that the

seal is not obstructed by bottles stored inside the cabinet.

∙ Following a power interruption, or if the unit has been

switched off on purpose, it may take 3 to 5 minutes before it

switches on again.

∙ Note: With the temperature control in position ‘0’, only

the compressoris switched off, while the fan is still

running.

Interior lighting

∙ The interior light can be switched on by means of the

separate On/Off switch.

∙ Caution: do not remove the cover of the interior LED

light. If there should be any malfunction, please contact the

customer service for assistance.

Reversible door

The design provides for the door to be reversed, i.e. for right-

hinged (default installation) to become left-hinged.

Warning: Always disconnect the unit from the mains before

any maintenance or repair work is carried out.

Before you get started, please note the following:

∙ Always ensure that the correct number of washers are used

on the hinge bolts.

∙ To ensure that the door can close tightly against the frame,

take the utmost care that it is properly aligned during re-

assembly.

1. Lower the unit carefully onto its back.

2. Remove the panel (10) by pulling it outwards.

3. Remove the two screws (7) and take off the bottom hinge

bracket (8), together with the set of washers (6) on the

hinge pin, and the spacer element (5).

4. Remove the two screws from the angled bracket (11) and

take it off.

5. Slide the door (4) off the top hinge pin and take it off.

6. Remove the hinge pin (2) together with the nut (1) and

washers (3) from the top hinge bracket, and ﬁ t the entire

assembly to the opposite side of the cabinet.

7. Turn the door through 180°, and then slide it over the

re-positioned top hinge pin (2).

8. Fit the hinge pin of the bottom hinge bracket (8) into the

door.

9. Replace the bottom hinge bracket (8) together with the

set of washers and the spacer element (5) to the cabinet,

using the screws (7).

10. Screw the angled bracket (11) to the opposite side of the

unit.

11. Re-attach the panel (10).

12. Return the whole unit to its upright position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9878 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info