Bedienungsanleitung Severin KS 9883 (Seite 14 von 56) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Schwedisch)

712734

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

The unit is activated by connecting it to the mains. It is only switched off completely when

the plug is removed from the wall socket.

Note: with the temperature control in its OFF-position, only the compressor is switched off.

The temperature in the cabinet can be adjusted by using the temperature control. We

recommend setting the temperature control initially to Normal. After a certain time, the

actual temperature should then be checked with a thermometer, and adjustments made if

necessary. Turning the temperature control clockwise will decrease the temperature, while

turning anti-clockwise will increase it.

The interior light can be switched on by means of the separate On/Off switch.

Changing the interior light bulb

Remove the plug from the wall socket.

Use a suitable screw-driver to remove

the screw (5) behind the light cover

(4).

Slide the cover (4) slightly to the rear

and take it off.

Take out the defective bulb (1) and fit a new 10W-bulb (max. 15 W).

Slide the cover (4) back into position, replace the screw (5) and tighten it.

Storing wine

The temperature in the cabinet largely depends on factors such as the ambient

temperature, the setting and the number of wine bottles stored.

Initially, the temperature control should be set to position Normal. If the cooling effect is

too strong, turn the temperature control anti-clockwise (towards Min); if it is

insufficient, turn it clockwise (towards Max).

Because of the way the air circulates, different areas of the refrigerator cabinet are

affected differently.

The coldest area is in the lower part of the cabinet, and is most suitable for storing wines

that require more cooling, such as white wines.

The warmest area is in the higher part of the cabinet, and is suitable for storing wines

that require less cooling, such as red wines.

Always ensure that the door is properly closed and that the seal is not obstructed by

bottles stored inside the cabinet.

De-frosting and cleaning

The integral vapouriser is sealed in foam in the rear wall; you may therefore notice a build-

up of frost around the rear area. This layer of frost will start melting when the compressor is

not working. Through a system of hoses, the melt-water drains into the collection tray below

the compressor, where it will be absorbed into the surrounding air. The unit does not

therefore require de-frosting, but only proper cleaning instead.

● To enable the melt-water to drain freely, always ensure that the channel and discharge

opening in the cabinet are free of any blockage.

Cleaning the unit / periods of non-use

remove the plug from the wall socket

remove the bottles from the cabinet

leave the door open

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9883 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info