Bedienungsanleitung Severin KS 9894 (Seite 10 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

603082

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

connected to the mains.

∙ When the unit is ﬁ rst switched on, a slight ‘new’ smell may

be noticed. However, this will disappear once the cooling

process has begun.

Installation

∙The appliance should be set up in a well-ventilated, dry room.

∙It should be operated in conditions where the relative humidity

is no more than 70 %.

∙The product data sheet contains details of the ambient

temperature range suitable for this appliance.

∙Do not use the appliance outdoors.

∙Ensure that the plug is accessible and can be removed from the

wall socket at any time.

∙Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers etc). If

this cannot be avoided, however, suitable insulation must be in

installed between the heat source and the unit.

∙The unit must not be installed inside a cabinet, nor directly

below a hanging cupboard, shelf or similar object.

∙Ensure that the door can swing open to an angle of 90°.

∙If the ﬂ oor is uneven, the adjustable feet on the unit can be

used to compensate and ensure optimum stability.

Ventilation

The heated air around the unit must be able to circulate freely.

Therefore, ensure that the circulation around and above the

unit is not obstructed.

The clearance must be at least 150 mm.

Temperature control

∙ The unit is activated by connecting it to the mains. It is only

switched off completely when the plug is removed from the

wall socket.

∙ The temperature in the refrigerator cabinet can be adjusted

by setting the temperature control (1-7). Turning the control

clockwise will decrease the temperature, while turning it anti-

clockwise will increase it.

∙ The temperature can be set within a 5 to 18°C range.

∙ The temperature in the cabinet largely depends on factors

such as the ambient temperature, the setting and the

number of wine bottles stored.

∙ We recommend using a thermometer to check the actual

temperature inside the cabinet and make adjustments as

necessary.

∙ Always ensure that the door is properly closed and that the

seal is not obstructed by bottles stored inside the cabinet.

∙ Following a power interruption, or if the unit has been

switched off on purpose, it may take 3 to 5 minutes before it

switches on again.

∙ Note: In position ‘0’, the cooling function is switched

off, though the appliance is still connected to the mains.

Interior lighting

∙ The interior light can be switched on by means of the

separate On/Off switch.

∙ Caution: do not remove the cover of the interior LED

light. If there should be any malfunction, please contact the

customer service for assistance.

Storing wine

The following temperatures are suitable for various wines:

Red: 15 -18°C

Dry/white: 10 -15°C

Sparkling/champagne: 5 - 9°C

De-frosting and cleaning

∙During operation, you may notice a build-up of frost around

the integral evaporator sealed into the rear of the inside

cabinet. This layer of frost will start melting when the

compressor is not working. Through a system of hoses,

the melt-water drains into the collection tray below the

compressor, where it will be absorbed into the surrounding

air.

∙The unit does not therefore require de-frosting, but only

proper cleaning.

∙ To enable the melt-water to drain freely, always ensure that

the channel and discharge opening in the cabinet are free of

any blockage.

∙Any water collecting in the bottom should be removed.

∙Remark: Do not use abrasive tools, materials containing

alcohol or harsh cleaning solutions. Do not use any electrical

appliances, such as steam cleaners, for de-frosting or

cleaning.

∙Always remove the plug from the wall socket before

cleaning.

∙Do not pour water over or inside the unit.

∙For frequent cleaning we recommend the use of warm water

with some mild detergent.

∙ The cabinet should be cleaned once a month.

∙Any accessories should be cleaned separately with soapy

water. Do not put them in a dishwasher.

∙After cleaning, thoroughly clean all surfaces with fresh water

before wiping them completely dry. When re-inserting the plug

into the wall socket ensure that you have dry hands.

∙To save energy and to ensure optimum performance, the

compressor (at the rear) should be carefully cleaned at least

twice a year, with a brush or a vacuum cleaner.

Trouble-shooting

∙Certain typical sounds can be heard when the appliance is

switched on. These sounds are caused by:

∙the electric motor

within the compressor

assembly; during

compressor start-up

the sound level will be

slightly higher for a

short time.

∙the cooling agent

ﬂ owing through the circuit.

∙In addition, the side of the housing may become warm. This

heat is caused by dissipation of the heat generated inside

the cabinet.

The following table lists possible malfunctions, their probable

causes and solutions. In the event of operational problems,

check ﬁ rst whether a solution can be found using this table. If

the problem persists, disconnect the appliance from the mains

Severin KS 9894 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Severin KS 9894

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info