Bedienungsanleitung Severin KS 9903 (Seite 18 von 40) (Deutsch, Englisch, Holländisch, Französisch)

712701

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

out food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to the

section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For detailed

information on the temperature settings, please refer to the

section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the electrical

motor within the

compressor assembly;

during compressor

start-up the sound level

will be slightly higher for

a limited period of time.

∙ caused by the cooling

agent ﬂ owing through the circuit.

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

p roblems, check ﬁ rst whether a solution can be found using this

table. If the problem persists, disconnect the appliance from the

mains power and contact our Customer Service Department.

Transporting the appliance

To prevent damage to the unit during transport, ensure that all

accessories and components inside and around the appliance

are securely fastened.

The unit must only be transported in its vertical position; do not

tilt any more than 30°.

Once the unit has been positioned, wait for about 30 minutes

before it is connected to the mains.

If the unit has been tilted more than 30° during transport, allow

it to stand in an upright position for at least 4 hours before it is

connected to the mains.

Disposal

This appliance has been manufactured from

recyclable materials. After removing the plug from the

wall socket, the unit should be rendered unusable by

cutting off the power cord before disposing of it

through special waste collection points in accordance with local

regulations. The refrigerant and the chemical agent in the

insulation foam must be disposed of through a competent

agency. Take special care not to damage the cooling circuit

before the unit is handed over for such disposal.

Problem Possible cause and solution

The appliance is not working at all.

∙ There is a power failure

∙ The main fuse has blown.

∙ The temperature control is set to ‘0‘.

∙ The fuse in the wall socket (if applicable) has blown. This can be checked by

connecting another electrical device to the socket and checking for function.

The temperature inside the freezer

compartment is not low enough.

∙ Too much food has been stored in the appliance.

∙ The doors are not properly closed.

∙ There is too much dust on the condenser.

∙ Insufﬁ cient ventilation: the unit is too close to a wall or other structure or object.

∙ The temperature control is set too low.

The normal operating sound changes or

becomes louder.

∙ Check for proper positioning (uneven ﬂ oor?).

∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing

them to vibrate?)

∙ Are there any objects on top of the unit which might be vibrating?

Water is collecting on the bottom of the unit.

The melt-water drain system is blocked. Remove the blockage and clean the

system.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9903 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info