Bedienungsanleitung Severin KS9766 (Seite 13 von 40) (Deutsch, Englisch, Holländisch, Französisch)

603059

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

9. Instructions for using freezer

10. Ice-cube tray

11. Storage shelf

12. Compressor

13. Melt-water evaporation tray

14. Condenser

Before using for the ﬁ rst time

∙ Remove any exterior and interior packaging materials

completely, including the adhesive strips.

∙ The packaging materials must be properly disposed of.

∙ Fit the two enclosed spacer elements (1) into the

corresponding guide slots on the rear (2).

∙ Before it is connected to the mains, the unit must be

thoroughly checked for transport damage, including its

power cord.

∙ Clean the unit as described in the section De-frosting and

cleaning.

∙ The unit should only be transported in its vertical position;

do not tilt any more than 30°.

∙ Once the unit has been positioned, wait for about 30

minutes before it is connected to the mains.

∙ If the unit has been tilted more than 30° during transport,

allow it to stand upright for at least 4 hours before it is

connected to the mains.

∙ When the unit is ﬁ rst switched on, a slight ‘new’ smell may

be noticed. However, this will disappear once the cooling

process has begun.

Installation

∙ The appliance should be set up in a well-ventilated, dry room.

∙ It should be operated in conditions where the relative

humidity is no more than 70 %.

∙ The product data sheet at the end of this manual contains

details of the ambient temperature range suitable for this

appliance.

∙ Do not use the appliance outdoors.

∙ Ensure that the plug is accessible and can be removed from

the wall socket at any time.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers etc.). If

this cannot be avoided, however, suitable insulation must be in

installed between the heat source and the unit.

∙ The unit must not be installed inside a cabinet, nor directly

below a hanging cupboard, shelf or similar object.

∙ In the case of uneven ﬂ oors, the adjustable feet on the unit

can be used to compensate and ensure optimum stability.

Set-up dimensions

Ventilation

The heated air around the rear of the unit must be able to circulate

freely.

Ensure, therefore, that the air circulation behind the unit is not

obstructed.

Caution: Ensure at all times that the rear ventilation

openings around the top cover are not obstructed.

Reversible door

If required, the door may be reversed, i.e. from right-hinged (default

installation) to left-hinged.

To avoid the risk of personal injury or damage to the unit, two people

are needed to reverse the door.

Warning: Always disconnect the unit from the mains before

any maintenance or repair work is carried out.

Before you get started, please note the following:

∙ Always ensure that the correct number of washers is used

on all hinge bolts and screws.

∙ So that the doors can close tightly against the frame, take

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS9766 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info