Bedienungsanleitung Severin PG 8114 (Seite 11 von 64) (Alle Sprachen)

799269

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

142 x 208 mm

Before using for the rst time

∙ Remove any packaging materials and stickers from the

appliance.

∙Cleanthegrillrack,reectortrayandwind-guardwith

warm soapy water; wipe thoroughly dry afterwards.

∙ Assemble the appliance as described in Preparing the

unit.

∙ Let the grill heat up for approximately 10 minutes at

maximum power without any food (see ‘Boost-zone’

grilling). This will remove the smell typically encountered

whenrstswitchingonagrill.Alittlesmokemaybe

emitted; for that reason, adequate ventilation should

be ensured by opening windows or balcony doors; an

extractor hood is also suitable.

Grill assembly

∙ Assemble the grill as shown in the diagrams:

∙Placethereectortrayintothegrillhousing.

∙Fit the heating element with junction box into the

reectortray.Theapplianceisequippedwithasafety

switch. The unit can be operated only with the junction

box properly installed.

∙Fitthegrillracksothatthestudsontheracktintothe

correspondingopeningsinthereectortray.

∙Fitthewind-guardelementsrstattherearintothe

recesses on the grill rack, and then secure them on

the grill rack frame.

Base stand assembly

∙ For grill models with base stand, assemble the stand as

shown in the diagram:

∙Fit the four legs into the frame; ensure they are

locked.

∙Fit the storage rack into the corresponding recesses

in the legs.

∙Ensure that the stand is stable.

∙Place the assembled grill on top.

Preparing the unit

∙ Assemble the appliance as described in Grill assembly.

For grill models with base stand, refer to Base stand

assembly.

∙FillthereectortraywithwatertotheMax marking (max

900 ml). Do not pour water on the heating element or its

sensor.

Hint!

Duringgrilling,thewaterinthereectortrayshouldbe

replenished in good time. Caution: Always disconnect

theappliancefromthemainsbeforere-lling.

∙ Connect the appliance to the mains.

∙ The light ring lights up blue, the unit is ready for use.

Rotary control

The rotary control is used for function selection or switching

off (Sleep mode).

Turn:

Select the Function/Temperature/Timer.

Push - short:

Conrmtheselection.

Push - two seconds:

1 x: return to stand-by mode to change a function

2 x: return to sleep mode

Rotary control - light ring

The light ring indicates the current operating mode:

No light:

The unit is in sleep mode.

Blue light:

The unit is in stand-by mode.

Flashing:

The grill rack has not yet reached the selected temperature.

The unit is heating up or cooling down.

Steady:

The selected temperature has been reached.

Orange:

Grilling 80-320 °C

Red:

Boost-zone 330-500 °C

Timer

The timer is used to monitor the grilling time. It can be set

from 1 min to 23 h 59 mins. Beep signals indicate that the

running time has elapsed; the heating element remains

switched on.

∙ Turn the rotary control until lights up.

∙Presstherotarycontrolbrieyandturntoselectthe

hours.

∙Presstherotarycontrolbrieyandadjusttheminutes.

∙Conrmthetimesettingbybrieypressingthecontrol.

Thecolonstartsashing;oncethetimehaselapsed,

beep signals are heard.

∙ To return to stand-by mode, press the rotary control for

two seconds.

∙ Alternatively, set the timer to 0:00, and press the control

brieytoreturntostand-bymode.

∙ If the heating is switched off after the timer is set, the

appliance will change to sleep-mode 5 minutes after the

last input, i.e. the timer is switched off.

∙ If the timer is set with the heating already off, it will

continue until the pre-selected time is reached, when the

unit changes to sleep-mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin PG 8114 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info