Bedienungsanleitung Severin PG 8117 (Seite 10 von 52) (Alle Sprachen)

799274

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

142 x 208 mm

Before using for the rst time

∙ Remove any packaging materials and stickers from the

appliance.

∙Cleanthegrillrack,reectortrayandwind-guardwith

warm soapy water; wipe thoroughly dry afterwards.

∙ Assemble the appliance as described in Preparing the

unit.

∙ Let the grill heat up for approximately 10 minutes at

maximum power without any food (see ‘Boost-zone’

grilling). This will remove the smell typically encountered

whenrstswitchingonagrill.Alittlesmokemaybe

emitted; for that reason, adequate ventilation should

be ensured by opening windows or balcony doors; an

extractor hood is also suitable.

Grill assembly

∙ Assemble the grill as shown in the diagrams:

∙Placethereectortrayintothegrillhousing.

∙Fit the heating element with junction box into the

reectortray.Theapplianceisequippedwithasafety

switch. The unit can be operated only with the junction

box properly installed.

∙Fitthegrillracksothatthestudsontheracktintothe

correspondingopeningsinthereectortray.

∙Fitthewind-guardelementsrstattherearintothe

recesses on the grill rack, and then secure them on

the grill rack frame.

Base stand assembly

∙ For grill models with base stand, assemble the stand as

shown in the diagram:

∙Fit the four legs into the frame; ensure they are

locked.

∙Fit the storage rack into the corresponding recesses

in the legs.

∙Ensure that the stand is stable.

∙Place the assembled grill on top.

Preparing the unit

∙ Assemble the appliance as described in Grill assembly.

For grill models with base stand, refer to Base stand

assembly.

∙FillthereectortraywithwatertotheMax marking (max

900 ml). Do not pour water on the heating element or its

sensor.

Hint!

Duringgrilling,thewaterinthereectortrayshouldbe

replenished in good time. Caution: Always disconnect

theappliancefromthemainsbeforere-lling.

∙ Connect the appliance to the mains.

∙The unit is ready for use.

Grilling ‘Standard’ up to 320 °C

Togrillsausages,poultry,shetc.Fornishingorkeeping

warm steaks.

The entire grill surface is heated.

∙ Set the rotary control to the select the desired position

between min und •. The light ring shows steady

orange.

∙ Let the appliance heat up for around 10 minutes, and

then place the food on the grill surface.

Grilling ‘Boostzone’ 500 °C

For searing or light grilling of steaks.

The boost-zone is located to the right; the left side is

heated to approx. 320 °C.

∙Turn the rotary control to BOOSTZONE. The light ring

shows steady red.

∙ Let the appliance heat up for around 10 minutes, and

then place the food on the boost-zone.

∙ For subsequent cooking, lower the temperature or shift

the food to the left on the grill surface.

After grilling

∙ Always disconnect the unit from the mains and allow it to

cool down after grilling.

Cleaning and care

∙ Ensure that the grill is thoroughly cleaned after use.

∙ Before cleaning the grill, ensure it is disconnected from

the power supply and has completely cooled down.

∙ Do not use metallic pads or abrasive cleaning agents.

∙ Remove the wind-guard and grill rack and clean them

in a dish-washer or with warm soapy water. To remove

persistent food residues, they can be left soaking for a

while.

∙ Remove the heating element with the junction box. To

avoid the risk of electric shock, do not clean the heating

element with water and do not immerse it in water. The

junction box may be wiped with a slightly damp lint-free

cloth.

∙Takeoffthereectortrayandcleanitinadish-washer

or with warm soapy water. To remove persistent food

residues, it can be left soaking for a while.

∙All other parts can be cleaned with a cloth soaked

in soapy water, and should be wiped completely dry

afterwards.

Hint!

Tohelpcleanthewind-guard,grillrackandreectortray,

baking powder may be used. Mix a paste from water and

baking powder, rub the paste onto the affected areas

and let it take effect for a while. Clean with a soft brush/

sponge and rinse thoroughly afterwards.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin PG 8117 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info