Bedienungsanleitung Severin PG 9739 (Seite 15 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch)

713193

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

sufﬁ cient time to cool down before

carrying, transporting or storing it. Pour

out any remaining water after use.

∙ Ensure that the grill is not stored

outdoors, or in any other location where

it might be subjected to extremes of

temperature or high humidity.

∙ No responsibility is accepted if damage

results from improper use, or if these

instructions are not complied with.

∙ This product complies with all binding CE

labelling directives.

Grill assembly

The barbecue grills are available in different

conﬁ gurations.

When assembling the grill, always refer to

diagram A corresponding to your particular

grill model. Follow the steps below:

∙ Place the grill pan inside the plastic

housing.

∙ Place the heating element into the grill

pan.

∙ Fit the grill rack on top.

∙ If required, additional accessories may

be ﬁ tted according to diagram A for your

particular grill model.

Grill models with additional base stand:

Assemble the base stand according to the

schematic diagram B. Place the grill onto the

stand in such a way that the small feet under

the grill connect in the top of the vertical legs

of the base stand; ensure that the grill and

base stand are placed in a safe and stable

position.

The power cord should be routed in such a

way that no one is likely to trip over it.

Heating element

The junction box contains a safety switch.

Place the grill pan into the plastic housing

ﬁ rst, and then ﬁ t the heating element inside

the grill pan and housing. The safety switch

is activated automatically when the heating

element has been properly ﬁ tted. If not ﬁ tted

correctly, the appliance cannot be switched

on.

Before using for the ﬁ rst time

∙ Remove any packaging materials from

the appliance.

∙ Clean the grill rack and grill pan with

warm soapy water; dry thoroughly

afterwards.

∙ Assemble the grill as described above.

∙ Fill the grill pan with water up to the ‘Max’

marking.

∙ Insert the plug into a suitable earthed

power-outlet.

∙ Let the grill heat up for approximately 5

minutes without any food on the rack. This

will lessen the smell typically encountered

when ﬁ rst switching on a new grill (a slight

smell and a little smoke may be emitted -

ensure sufﬁ cient ventilation).

∙ For grill models with a thermostat control,

let the grill heat up with the control knob

set to its ‘MAX’ position.

Grilling

∙ The grill pan must be ﬁ lled with water up

to the ‘Max’ marking.

∙ Grill models without thermostat control:

Insert the plug into a suitable earthed

power-outlet.

∙ Grill models with thermostat control:

Insert the plug into a suitable earthed

power-outlet. Set the thermostat control

knob to its ‘Max’ position. The indicator

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin PG 9739 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info