Bedienungsanleitung Severin WK 3460 (Seite 11 von 68) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

654728

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

excessive force has been used to pull the

power cord, it must no longer be used:

even invisible damage may have adverse

effects on the operational safety of the

appliance.

∙ The appliance must be used only on a

heat-resistant, level surface.

∙ Do not operate the appliance below a

hanging cupboard or similar object; there

is a risk that escaping steam may be

trapped underneath.

∙ Do not allow the appliance or its power

cord to come into contact with open

ﬂ ames or any hot surfaces such as

hot-plates.

∙ Do not let the power cord hang free, and

keep the cord well away from hot parts of

the housing.

∙ Always remove the plug from the wall

socket,

- in case of any malfunction,

- after use,

- during cleaning.

∙ No responsibility is accepted if damage

results from improper use, or if these

instructions are not complied with.

Thermal safety cut-out

The preset thermal safety cut-out protects

the heating element from overheating should

the appliance be erroneously switched on

without any water, or if the heating element

is calciﬁ ed. Once the safety cut-out has

switched off the kettle, it must be allowed to

cool down sufﬁ ciently, or must be descaled

before it is switched on again.

Keep-warm function

Once the boiling process is ﬁ nished, the

water may be kept hot for another 30

minutes by pressing the HOLD TEMP button

before or after the heating process. However,

the keep-warm function is automatically

cancelled if the water container is removed

from the base for more than 30 minutes,

The indicator light on the HOLD TEMP

button is on while this function is active.

Before using for the ﬁ rst time

To clean the kettle, boil and discard the ﬁ rst

ﬁ lling of water.

Boiling water

∙ Remove the water container from its base.

∙ Push the release button to open the lid,

and ﬁ ll the container with water to the

desired level, observing the Max. marking.

∙ Close the lid and replace the container

on its base. Insert the plug into a suitable

wall socket.

∙ Once the appliance is connected to the

mains, the indicator lights on the operating

buttons will ﬂ ash three times.

∙ Select the desired temperature and press

the START/CANCEL button to turn the

appliance on. During the heating period,

the temperature can be changed at any

time.

∙ The heating process begins.

∙ The indicator light on the START/

CANCEL button comes on and that on

the temperature selection button starts

ﬂ ashing.

∙ After reaching boiling point (or the selected

temperature), the appliance switches off

automatically. The corresponding button

shows a steady light.

∙ Around 30 seconds after the appliance

has switched off, the indicator lights on

the temperature selection and START/

CANCEL buttons will also go out.

∙ As long as the kettle is connected to the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin WK 3460 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info