Bedienungsanleitung Severin WL 807 (Seite 10 von 46) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

713006

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

down, it may be switched on again.

 Before the appliance is used, the main body

as well as any attachment ﬁ tted should be

checked thoroughly for any defects. Should

the appliance, for instance, have been

dropped onto a hard surface, it must not

be used any longer: even invisible damage

may have adverse effects on the operational

safety of the appliance.

 Do not leave the appliance unattended

while in use.

 To prevent damage to the power cord,

- do not bend or kink the cable, especially

where it leaves the housing,

- do not pull on the cord,

- do not coil the power cord around the

appliance.

 Do not place the appliance on any surface

sensitive to heat during or immediately after

use.

 Do not operate the appliance if it is stored

on the hanging loop.

 Make sure that the hot round brush is kept

well away from the scalp.

 When removing the plug from the wall

socket, never pull on the power cord;

always grip the plug itself.

 Always switch off and remove the

plug from the wall socket

- after use, as well as

- in cases of malfunction, and

- during cleaning.

 No responsibility will be accepted if damage

results from improper use, or if these

instructions are not complied with.

 This appliance is intended for domestic or

similar applications, such as in

- shops, ofﬁ ces and other similar working

environments,

- agricultural areas,

- hotels, motels etc. and similar

establishments,

- bed and breakfast type environments.

 In order to comply with safety regulations

and to avoid hazards, repairs of electrical

appliances must be carried out by qualiﬁ ed

personnel, including the replacement of the

power cord. If repairs are needed, please

send the appliance to one of our customer

service departments. The address can be

found in the appendix to this manual.

Operation

Changing the round brush

The round brushes can be changed by simply

pulling the brush off and sliding the other

one on.

Caution: Do not press the curl release button

while changing a brush.

Switch positions

The appliance is equipped with a 4-position

switch allowing for various settings:

Functions:

0 = Off

I = Half power

II = Full power

❄ = Cool-shot setting (cooling down)

Use

– The round brush is designed for shaping

the hair. To achieve this, the hair should be

divided into single strands (not too thick) and

then spread evenly over the brush, turning

them inwards or outwards as desired.

– Apply for a few seconds at a time only,

while letting the hot air take effect on the

hair.

– To ﬁ x a particular strand of hair, use the

cool-setting for a few seconds afterwards.

– Press the curl release button

to roll the

brush out of the strands of hair.

– Let the hair cool down sufﬁ ciently before

brushing it out.

General cleaning and care

 Before cleaning the appliance, ensure it is

disconnected from the power supply and

has cooled down completely.

 To avoid the risk of electric shock, do not

clean the appliance with water and do not

immerse it in water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin WL 807 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info