Bedienungsanleitung Shark EP035T2 (Seite 4 von 4) (Englisch)

668670

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

OPERATING INSTRUCTIONS

PRECAUTIONARY MEASURES

2. Before inserting the power plug

into the wall outlet, make sure that

your hands are dry.

1. Do not operate the vacuum

cleaner to close too heaters,

or radiators.

3. Do not vacuum any liquids.

6. Do not pick up anything that is

burning or smoking such as

cigarettes, matches or hot ashes.

7. Do not use without HEPA dust cup

filter in place.

5. When pulling out the power plug

from the wall outlet, pull the plug

not the power cord.

Important: If the suction opening in the unit or the hose become blocked, switch off

the vacuum cleaner and remove the blocking substance before you start

the unit again.

1. To open the dust

cup (container),

push button and

pull out the dust

cup. Verify that the

HEPA dust cup

filter is inside, then attach the

dust cup (container) to the

hand vacuum.

2. To use the Hand Vacuum with the

shoulder strap, attach it to the unit as

shown below.

How To Operate Your

Hand Vacuum

1. Hold the hand vacuum firmly in your

hand by the Handle.

2. Push the On/Off Power Switch to “On”

position.

3. Start vacuuming.

CAUTION: The Hand Vacuum is a

very powerful unit. Make sure that you

hold it firmly, otherwise it can slip out of

your hand and cause injury.

4. To use the flexible hose, push

the end of the hose into the

suction hole, then attach the

desired brush to the other end

of the flexible hose, as shown

below.

NOTE: When the Intelli-Sense Filter

Monitor

lights up, it means that the

dust cup is full or filter needs cleaning.

You must empty the dust from the dust

cup and clean the HEPA dust cup filter

right away. (See illustration below.)

NOTE: The pet hair removal

attachment is for use on upholstery,

drapes and other fabric surfaces to

remove lint, pet hair, etc. THE PET

HAIR REMOVAL ATTACHMENT IS

NOT INTENDED TO BE USED AS A

PET GROOMING DEVICE.

3. To attach the oval brush or the pet

hair removal attachment to the

Hand Vacuum, push attachment

into the suction hole,

as shown

below.

Important: This unit is equipped with a

motor protective thermostat. If for some

reason the vacuum cleaner should

overheat, the thermostat will automatically

turn the unit off. Should this occur:

• Push the On/Off button once.

• Disconnect the plug from the

power source.

• Check the source of overheating

problem. (i.e. clogged hose or

filter)

• If clogged hose or filter is found,

unclog the hose and replace the

filters.

• Wait at least 45 minutes before

attempting to reuse the vacuum.

• After unit has cooled down for

45 minutes, plug in the cleaner

and push the On/Off button. The

vacuum should start again.

• If the vacuum still does not start,

contact EURO-PRO at

1-800-798-7398.

Warning: Always unplug from electrical

outlet before opening the dust cup

(container).

Note: HEPA dust cup filter must be used

when operating the hand vacuum.

Using The Unit As A Hand

Vacuum

8. Before you start vacuuming,

make sure to remove large or

sharp objects that might

damage the vacuum.

4. Keep hair, loose clothing, fingers,

feet and all parts of body away from

openings.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Shark EP035T2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info