Bedienungsanleitung Shark Ion Robot RV850WV Series (Seite 6 von 19) (Englisch)

743741

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

sharkclean.comsharkclean.com

If the robot has no charge and cannot return to the

charging dock, place it on the dock manually.

When the cleaning cycle is complete, or if the battery

is running low, the robot will search for the dock.

If your robot doesn’t return to the dock, its charge

may have run out.

CHARGING THE SHARK ION™ ROBOT

IMPORTANT: The Shark ION Robot has a pre-installed rechargeable battery. Battery must be fully charged

before using.

To charge, the Power button on the side of the robot

must be in the ON position (I).

NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are

aligned with the dock by leaving a gap of half an inch between the dock face and the front of the robot. To ensure the robot

is docked correctly, refer to the Charge Indicator Lights section.

CHARGING THE SHARK ION™ ROBOT

NOTE: If the low charge light is blinking red, there is not enough charge for the robot to return to the dock. Manually

place the robot on the dock, leaving a half-inch space between the front of the robot and the face of the dock.

TIP: To preserve battery life, turn o the power switch if robot will not be used for a long period of time. Unit should be

recharged at least once every three months.

Clean

Max

Dock

CHARGE INDICATOR LIGHTS

The blue charge indicator lights show how much charge is remaining.

While the robot is charging, all three blue LED lights will cycle. When charging is complete, all three blue

lights will illuminate steadily.

If the robot is idle and away from the charging dock for 10 minutes, it will enter Sleep Mode, and the lights

will turn o.

If all the indicator lights are o, then the robot is in Sleep Mode, the power switch is turned OFF (O) or there

is no charge remaining. Turn the power switch ON (I). Press any button to ensure robot is not in Sleep Mode.

If all indicator lights remain o, there is no charge. Place the robot on the dock, leaving a half-inch space

between the front of the robot and the face of the dock. When the robot is docked correctly and begins to

charge, it will beep and the charge indicator lights will cycle.

Low ChargeMid ChargeNearly FullFull Charge

In Use

While

Charging

No Charge

or O

USING THE SHARK ION™ ROBOT

MANUAL CLEANING MODE

To manually start a cleaning cycle, press the Clean button on the robot

or on the mobile app. To stop the robot before it ﬁnishes cleaning and

automatically returns to the dock, press the button again.

IMPORTANT: Before cleaning an entire room for the ﬁrst time, we recommend that you ﬁrst test your robot on a small

section of the ﬂoor to ensure there is no scratching.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Shark Ion Robot RV850WV Series Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info