Bedienungsanleitung Shark SV745 (Seite 3 von 4) (Englisch)

668676

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Battery Pack Replacement & Disposal

This vacuum cleaner contains a nickel-

cadmium (Ni-Cd) batteries. Batteries must be

recycled or disposed of properly. Call your

nearest recycling center for information on the

recycling and disposal of nickel-cadmium (Ni-

Cd) batteries.

If uncertain as to how to remove the battery

pack, we suggest you take your wet/dry hand

vacuum to a reputable small appliance service

technician to have this service preformed.

Wall Mounting Bracket

1. Make sure that the intended wall area for

the wall mounting bracket to be drilled is

free from any hidden electrical wires,

water pipes and gas lines.

2. Select an appropriate place close to a

wall power outlet (120V., 60 Hz).

3. Do not mount near direct sunlight, near a

heat source or outdoors.

4. Select an appropriate drill type for the

material to be drilled.

5. Carefully measure and mark the location

of all bracket holes and then drill holes

and screw the wall mounting bracket onto

the wall.

The battery pack of your SV745 is replaceable,

however care should be taken when doing so.

Follow these steps when replacement is

required:

1. Open the battery pack compartment by

removing the single Phillips head screw

located in the recess at the rear of the unit.

NEVER open the battery compartment

except to change the battery pack when

required.

2. Remove battery compartment cover. Set

aside battery compartment cover with the

screw.

3. Carefully detach the two (2) electrical

connectors from the battery pack by pulling

straight out from the battery pack.

4. Lift out the battery pack and set aside.

5. Insert the new battery pack and re-connect

the terminals by pushing lead wires onto

battery tabs.

6. Tuck the wiring inside the battery

compartment so that the wiring does not

interfere with the battery compartment

cover when it is replaced.

7. Re-install the battery compartment cover

by sliding it over the battery towards the

front of the unit, making sure that the front

snap engages the body of the unit.

8. Replace the battery compartment cover

screw.

CAUTION

• Use only with the battery pack supplied

with the unit.

• Do not attempt to remove the battery

pack from the unit to charge it.

• Never attempt to throw the battery pack

or unit into a fire or incinerate it.

• Do not attempt to remove or damage the

battery casing.

• Battery must be recycled or disposed of

properly at the end of it's service life.

Hints for Spot Cleaning Carpets

Note: Before spot cleaning your carpet, test for

color fastness. Dampen a white cloth with the

cleaning solution that you will be using and test

a small area in a closet or under a piece of

furniture. Gently rub the cloth over the area.

Check each color for bleeding. If the cloth

remains white, it should be safe to clean the

carpet or upholstery. When using commercial

pre-cleaners spot removers, follow

manufacturers instructions and follow this

procedure with our Wet/Dry Vac.

1. Apply the pre-cleaner spot remover to the

carpet as per manufacturers instructions.

2. Using the Wet/Dry vacuum, suck the pre-

cleaner spot remover liquid from the

carpet.

3. Spray the same area with water.

4. Vacuum again to remove the water.

5. Repeat steps 3 and 4 again if necessary.

6. Empty the dust cup.

7. If you still see that the pre-cleaner has

not been completely removed, repeat steps

3 and 4 again.

8. If the stain has not been removed, repeat

steps 1 to 6 again.

NOTE: Pre-cleaner spot removers sometimes

do not remove tough stains. Please use a

professional carpet cleaning service if such is

the case.

Model SV745

12 V DC

OPERATING INSTRUCTIONS cont.

WARNING: NEVER use ordinary

batteries for replacement, as these may leak

and damage your vacuum cleaner. Use only

battery pack XBP745 provided by EURO-

PRO Operating LLC for replacement.

8. Extension Hose

9. Convertible Brush

10. Squeegee Nozzle

11. Charging Adapter

12. Crevice Tool

13. Recharging Stand

14. Charging Jack

1. Dust Cup (Container)

2. Dust Cup Release Button

3. On / Off Switch

4. Separator Housing

5. Dust Cup Filter

6. Charging Light Indicator

7. Main Unit

CAUTION: NEVER use the unit without

the battery compartment cover in place.

NOTE: Any other servicing should be

performed by an authorized service

representative.

NOTE: Cordless Wet/Dry Hand Vacuum Model SV745 is shipped

with the batteries uncharged. Charging of the unit for

16-20 hours prior to first use is required.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Shark SV745 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info