26402
92
Zoom out
Zoom in
Vorherige Seite
1/128
Nächste Seite
90
GENERAL INFORMATION
TONER CARTRIDGE
REPLACEMENT
The approximate quantity of toner remaining can be displayed by pressing and holding the COPY key
during standby or warm-up. See page 92. When the quantity of toner remaining is less than 25%,
obtain a new cartridge. When the toner cartridge replacement required icon ( ) appears in the display,
replacement of the toner cartridge will be needed soon. If you press the information key, the message
"Toner is low." will appear in the display. When the message "Add toner. Can not copy or print."
appears in the display, the toner cartridge must be replaced before copying can be resumed. Replace
the toner cartridge by following the procedure below.
KEY OPERATOR If the backlight change of the display is enabled using a key operator program, the
color of the backlighting will change to yellow when the message "Toner is low." appears and will
change to orange when the message "Add toner. Can not copy or print." appears. See page 16 of the
KEY OPERATOR'S GUIDE.
NOTE:
During a long copy run of a dark original, the message "Toner replenishment in progress." may
appear and the copier will stop, even though toner is left. The copier will feed toner for up to 2
minutes and then the START ( ) key indicator will light up. Press the START ( ) key to restart
copying.
1
Gently open the front cover.
2
Push the toner cartridge lock release lever and pull the toner cartridge
out. Remove the toner cartridge while supporting it with the left hand
at the green label portion.
For disposal of the old toner cartridge, contact your dealer.
NOTE:
After removing the toner cartridge, do not shake it or tap on it. Doing so may cause toner to leak
from the cartridge. Put the old cartridge immediately in the bag contained in the box of the new
cartridge.
For best copying results, be sure to use only SHARP Genuine
Supplies which are designed, engineered and tested to maximize the
life and performance of SHARP copiers. Look for the Genuine
Supplies label on the toner package.
GENUINE SUPPLIES
Toner cartridge
lock release lever
Grip
Ar-M208_sec.book 90 ページ 2002年6月13日 木曜日 午後2時37分
92

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sharp ARM208 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info