Bedienungsanleitung Sharp DVHR300u (Seite 10 von 126) (Englisch)

21204

Zoom out

Zoom in

Vorherige Seite

1/126

Nächste Seite

About Hard Disc (HDD)

This Recorder has a built in hard disc (abbreviated

“HDD”) for recording and playback. Beware of the

following points when setting up and using the Recorder.

Failure to observe precautions may cause damage to

the HDD itself or its content, failure of the disc to

operate, or recording of noise.

• Do not subject to any vibration or impact.

• Do not place at a cramped location which might block the

cooling fan or ventilation port on the back of the Re-

corder.

• Do not place at a location with severe temperature

variation.

s If the Recorder is set up at a location with severe

temperature variation, dew may form on and inside the

Recorder. If the Recorder is used with internal dew

formation present, this may cause HDD damage or

malfunction. We recommend keeping variation in room

temperature within 50˚F (10˚C) per hour.

• Do not place at a location with high humidity.

• Place the Recorder horizontally, never at an incline.

• When the power is on, do not unplug the power cord from

the AC outlet, turn off the breaker for the area where the

Recorder is set up, or move the Recorder.

s When moving the Recorder, first turn off the power and

then unplug the power cord from the AC outlet.

Recording Format

■ HDD recording is done using the variable bit rate

format for more efficient recording.

The following phenomena may occur.

With the variable bit rate format, the remaining amount

which can be recorded may increase or decrease relative

to the display of the remaining amount of HDD space.

• When the display indicates that the remaining amount of

HDD space is low, first delete unnecessary programs,

and then record with an extra margin in the amount of

remaining space.

• Even if you delete a program, the remaining amount may

not increase by the amount of deleted time. When

recording new video, record with an extra margin in the

amount of remaining space.

• With this Recorder, part of the HDD capacity is used as a

system management area.

Unrecordable Material

• This Recorder is equipped with a copy guard function

that prevents recording of video software or broadcast

programs that contain a signal that restricts copying in

accordance with copyrights and so forth.

• In the case a copy guard signal is contained in a source

video that occurs partway through recording, recording is

paused at that point. Recording resumes when the copy

guard signal is no longer present, while no recordings will

be made for the part where the copy prevention signal is

present.

In the unlikely event that there is some problem like loss

of recorded video or audio content due to a HDD

malfunction, please be aware beforehand that Sharp will

bear no responsibility to compensate for the content

which could not be recorded or edited, for the loss of

recorded or edited video, or for other related direct or

indirect damages.

■ If a power failure occurs

• The content being recorded or timer recorded will be

damaged if power failure occurs.

• The content being played back may be damaged.

■ For important recording

• If the HDD malfunctions, the content recorded on the

HDD may be lost. If you wish to save content perma-

nently, we recommend copying or moving the content

to DVD-RW or DVD-R.

NOTE

• If a message indicating a HDD error is displayed (such as

“CANNOT OPERATE DUE TO ERROR.”) and the HDD has

malfunctioned, you cannot replace the HDD by yourself.

If you disassemble the Recorder, the warranty will

become void. Also, recovery of data is impossible. If

playback is possible, re-record the recorded content onto

a DVD-R/RW disc, and contact your nearest Sharp

Authorized Service Center.

Hard Disc Operation

(Recording / Playback / Time Shift

Recording)

• If the Recorder is used in a cold location (a location at

low temperature), the drive will only allow live viewing

after power is turned on until the HDD is ready. During

this time, the Recorder will not allow Time Shift Viewing,

recording, display of recording lists or playback of

recorded programs. Please wait until the HDD is ready.

Initialization

• Initialization erases all video recorded on the HDD. Be

sure to dub important recordings onto DVD-R/RW discs

before initializing.

CPRM (control) Information

• There are 3 types of copy control signals: “Copy Freely”,

“Copy Once” and “Copy Never”.

“Copy Never” programs cannot be recorded on HDD.

When a “Copy Once” enabled program is copied from

HDD to DVD-RW, the video is not copied — it is moved

from the HDD to the DVD-RW (i.e. the content recorded

on the HDD is erased).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp DVHR300u Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info