231
Your POS terminal can be connected with a drink dispenser.
The summary of drink dispenser operations is shown below.
When an entry error is found, perform the following steps:
1. Check the error by the drink dispenser misoperation file reading or drink dispenser error reading.
Drink dispenser misoperation file reading REG or MGR mode
Clerk report OP X/Z or X1/Z1 mode
If there is misoperation data when you take an individual or full clerk X/Z report, the machine
waits for selection of one of the following three commands (RETRY, ABORT and IGNORE)
through the keyboard or menu.
1 RETRY: attempts to retry the report issuing job.
2 ABORT: cancels the report issuing job.
3 IGNORE: issues the report, disregarding that there is misoperation data. In the
case of the Z report, misoperation data is also reset.
Drink dispenser error reading X1/Z1 mode
2. Correct the error with the drink dispenser correction in the REG or MGR mode.
The error which relates to GLU codes can be corrected. However, the error which relates to PLU
codes or clerk codes cannot be corrected with the drink dispenser correction.
Procedure to return from Off-line to On-line mode
Case 1:
The drink dispenser was set to Off-line only for a short term and there have been no change in GLU
occupations (same guests at the same table).
The data-buffer of the drink dispenser can be emptied by using the DD reset function (Z1 mode). The POS
terminal - drink dispenser line is automatically set to On-line by this function.
Case 2:
The drink dispenser connection was set to Off-line for a long term. Therefore, the use of the DD reset
function is not applicable because GLU occupations have been changed, meanwhile. Empty the drink
dispenser data-buffer at the drink dispenser directly and set the POS terminal - drink dispenser line to On-
line manually.
