Bedienungsanleitung Sharp LC-37GD7 (Seite 26 von 42) (Englisch)

66384

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Programming recording (for logged in recorder)

You prepare the station marked with the  buttons for recording by

pressing the red button. In the following menu you conﬁ rm the timer

data or change them as required. Then a red dot is set in front of this

programme in the EPG programme list as an identiﬁ cation. If you select

this programme, you can delete the programme from the timer again

with the red button.

You can record a digitally transmitted programme and watch an analogue

programme at the same time or vice versa

✳

Note: Never select the sound format “Dolby Digital” during recording,

even if this is provided, since it cannot be recorded.

Call EPG menu:

Note: not with DVB-T stations in UK.

Call EPG menu

EPG menu

Select provider

Station selection

AVL timer list

Data capture on (for DVB + analog)

You will ﬁ nd the following settings in the EPG menu:

• “Select provider” • “Station selection” • “AVL timer list

• “Data capture”

Selection of provider/station

In case of analogue TV programmes, you can change the provider (the

station which transmits EPG data) to get EPG content for other pro-

grammes. You can do this under “Select provider”.

Select “Select provider” and call this menu with OK. If the station you

want to change to is not listed in the “Select provider” list, start the

provider search with the green button. This takes a while.

Or, if you know the station, press the yellow button for “Change provider

list”. Select the provider in the programme list and enter it with OK and

return to the provider selection with BACK.

Select the provider in the “Select provider” menu and press OK. Then a

programme range search is performed. The programmes offered by the

provider are displayed in a list.

If you want certain programmes to be omitted from the programme

guide, you can select and deactivate these in the "Station selection". Call

the programme selection with OK. Now all programmes are displayed

(the DVB programmes too). Programmes marked by “E” are analogue

terrestrial/cable programmes, programmes marked by “D” are digital

programmes ready for the programme guide. Select the programmes

you want to omit from the programme guide one after another and

deactivate each one with OK.

Data entry

After these settings or every time the switch is set off with the main

switch, the data must ﬁ rst be collected (only for analogue TV). To do

this, select the programme which you have deﬁ ned as a provider and

leave it switched on for about 1 hour or switch the set to standby. After

about 2 minutes the mode indicator on the TV set lights orange. The

data entry begins and lasts about 1 hour. The data are also automatically

collected between 2 and 5 in the morning when the TV is switched to

standby.

A prerequisite for data entry is that “Data capture” is “on (for DVB +

analog)” in the EPG menu.

Note: If the main plug is pulled out or the ON/OFF-button is pushed, all

EPG data are lost.

If you cannot receive any EPG providers, for example, you should switch

off the data entry.

Switch on TV when marked

You can have the TV switched on automatically from standby at the be-

ginning of the memorised programme. If you are not present at the time,

a safety prompt makes sure the TV switches off again after 5 minutes.

Modes of operation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp LC-37GD7 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info