Bedienungsanleitung Sharp R21HV (Seite 5 von 24) (Englisch)

22540

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Hole

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding

plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the

National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding

reduces risk of electric shock by providing an escape wire for the electric current.

WARNING – Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more

protected electrical supply. It is recommended that a separate circuit serving

only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged into

a wall receptacle that is properly installed and grounded. Should you only

have a 2-prong outlet, have a qualified electrician install a correct wall recep-

tacle.

A 3-prong adapter may be purchased and used temporarily if local codes

allow. Follow package directions.

A short power-supply cord is provided to reduce risk of becoming entangled in

or tripping over a longer cord.

Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension cord

that has a 3-blade grounding plug and a 3-slot receptacle that will accept the

plug on the microwave oven. The marked rating of the extension cord should

be AC 115-120 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it can be

pulled on by children or tripped over accidentally.

Notes: 1. If you have any questions about the grounding or electrical in-

structions, consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage to

the oven or personal injury resulting from failure to observe the

correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave

oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check

position and signal of receiving antenna.

GROUNDING INSTRUCTIONS

INSTALLATION

Because your Sharp Commercial Microwave Oven will be used fre-

quently, place it so that there is easy access for all users.

1. Be sure all electrical requirements are met. See above.

2. Air intake openings are on the back of the unit. Install the unit at least

2 inches away from the nearest wall to permit adequate ventilation for

proper cooling and air flow in the oven.

3. Install the unit where no excessive heat or steam are generated. Do

not place next to an oven or cooking surface.

4. The unit may be secured to a countertop or stand. There is a screw

hole in the bottom of the unit. After the oven is permanently placed, drill

a hole through the counter top for a 3/16 inch self-tapping screw. The

hole should be 1 inch from the left side of the outer case cabinet and

7-1/8 inches back from the front edge of the cavity face plate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp R21HV Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info