Bedienungsanleitung Sharp SJ-B2330E1I (Seite 12 von 20) (Englisch)

647289

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

EN -12-

CHAPTER -3: USING YOUR FRIDGE FREEZER

Cooler Temperature Settings

• The Initial temperature value for the Cooler Setting indicator is +4°C.

• Press the Cooler Set button once.

• When you rst push this button, the last value set appears on the setting indicator of

the cooler.

• Whenever you press on this button a lower temperature will be set. (+8°C, +6°C, +5°C,

+4°C, +2°C, super cool)

• When you push the Cooler Set button until the supercool symbol appears on the Cooler

Setting indicator, and if you do not push any button in 1 seconds the Super Cool symbol

will ash.

• If you continue to press the button, it will restart from +8°C.

• The temperature value selected before Holiday mode, Super Freeze mode, Super Cool

mode or Economy mode is activated will remain the same when the mode is over or

cancelled. The appliance continues to operate with this temperature value.

Recommended settings for your appliance temperature

Freezer partition

Refrigerator

compartment

Remarks

-18 °C 4 °C For regular use and best performance.

-20 °C, -20 °C or -24 °C 4 °C Recommended when environmental temperature exceeds 30°C.

SF 4 °C Must be used when you wish to freeze food in a short period of time.

-18 °C, -20 °C, -20 °C

or -24 °C

2 °C

These temperature settings must be used when the environmental

temperature is high or if you think the refrigerator compartment is not

cool enough because the door is being opened frequently.

-18 °C, -20 °C, -20 °C

or -24 °C

Must be used when the refrigerator compartment is overloaded with

food or when there is food to be cooled instantly.

Warnings About Temperature Adjustments

• Your temperature adjustments will not be deleted when an energy breakdown occurs.

• It is not recommended that you operate your fridge in environments colder than 10°C.

• Temperature adjustments should be made according to the frequency of door openings, the quantity of food

kept inside the fridge and ambient temperature of the placement of your fridge.

• Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after

being plugged in, this is so it is completely cooled. Do not open the doors of your fridge and do not place food

inside it during this period.

• A 5 minute delay function is applied to prevent damage to

the compressor of your fridge, when you take the plug out

and then plug it back in again after an energy breakdown

has occurred. Your fridge will start to operate normally after

5 minutes.

• Your fridge is designed to operate in the ambient

temperature intervals stated in the standards, according

to the climate class stated in the information label. We

do not recommend operating your fridge out of the stated

temperatures value limits in terms of cooling effectiveness.

Note: If the ambient temperature is higher than 38°C, the compartment temperature cannot be set to -22°C, -23°C or

-24°C. It can only be set to -16°C, -17°C, -18°C, -19°C, -20°C or -21°C.

Climate Class Ambient Temperature

T Between 16 and 43 (°C)

ST Between 16 and 38 (°C)

N Between 16 and 32 (°C)

SN Between 10 and 32 (°C)

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in

the coldest area.

To better store the food in your refrigerator, especially in the coldest area, make sure the message “OK”

appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set

properly

It may be difcult to see the indicator, make sure it is properly lit.Each time the temperature setting device is

changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,

with a new temperature setting. Please change the position of the temperature setting device progressively and wait at

least 12 hours before starting a new check and potential change.

NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,

it is normal for the indication “OK” not to appear in the temperature setting indicator. If there is an abnormal build up

of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded

appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until

compressor off periods are obtained again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp SJ-B2330E1I Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info