Bedienungsanleitung Sharp SJ-BA20IEXIE (Seite 13 von 108) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

787033

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

EN -11-

CHAPTER -3: USING YOUR FRIDGE FREEZER

Warnings About Temperature Adjustments

• It is not recommended that you operate your fridge in environments colder than 10°C.

• Temperature adjustments should be made according to the frequency of door openings, the quantity of food

kept inside the fridge and ambient temperature of the placement of your fridge.

• Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after

being plugged in, this is so it is completely cooled. Do not open the doors of your fridge and do not place food

inside it during this period.

• A 5 minute delay function is applied to prevent damage to the compressor of your fridge, when you take the

plug out and then plug it back in again after an energy breakdown has occurred. Your fridge will start to operate

normally after 5 minutes.

• Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to

the climate class stated in the information label. We do not recommend operating your fridge out of the stated

temperatures value limits in terms of cooling e󰀨ectiveness.

• This appliance is designed for use at an ambient temperature within the 10°C - 43°C range.

Climate class and meaning:

T (tropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43 °C.

ST (subtropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to

38 °C.

N (temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to

32 °C.

SN (extended temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from

10 °C to 32 °C.

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in

the coldest area.

To better store the food in your refrigerator, especially in the coldest area, make sure the message “OK”

appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set

properly

It may be di󰀩cult to see the indicator, make sure it is properly lit.Each time the temperature setting device is

changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,

with a new temperature setting. Please change the position of the temperature setting device progressively and wait at

least 12 hours before starting a new check and potential change.

NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,

it is normal for the indication “OK” not to appear in the temperature setting indicator. If there is an abnormal build up

of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded

appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until

compressor o󰀨 periods are obtained again.

Store food in the coldest area of the refrigerator.

Your foods will be better stored if you put them in the most appropriate

cooling area. The coldest area is just above the crisper.

The following symbol indicates the coldest area of your refrigerator.

To be sure to have a low temperature in this area, make sure the shelf is

located at the level of this symbol, as shown in the illustration.

The upper limit of the coldest area is indicated by the lower side of the sticker (head of

the arrow). The coldest area upper shelf must be at the same level with the arrow head.

The coldest area is below this level.

As these shelves are removable, make sure they are always at the same level with these

zone limits described on the stickers, in order to guarantee temperatures in this area.

Freezer temperature settings

• The initial temperature value for the Freezer Setting Indicator is -18°C.

• Press the set freezer button once.

• When you rst push this button, the last set value will blink on the screen.

• Whenever you press this button, a lower temperature will be set (-16°C, -18°C, -20°C, -22°C,

-24°C Super freeze).

• When you push the set freezer button until the Super freeze symbol appears, and if you do not

push any other button within 1 second, Super Freeze will ash.

• If you continue to press it, it will restart from -16°C.

• The temperature value selected before Holiday Mode, Super Freeze Mode, Super Cool Mode or

Economy Mode is activated and will remain the same when the mode is over or cancelled. The

appliance continues to operate with this temperature value.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp SJ-BA20IEXIE Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sharp SJ-BA20IEXIE

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info