564741
15
Zoom out
Zoom in
Vorherige Seite
1/308
Nächste Seite
15
Preparations for the rst-time
ice making
Wash the water tank and the ice storage box.
Carry out the Ice tray cleaning mode to clean the ice tray and
the pipe.
(There may be odor or dirt within the automatic ice maker.)
Ice making
WARNING
Use potable water only.
To start operation
At rst, all the ice making mode are set “OFF”.
1
Select one of the four modes.
Normal ice Clear ice (normal size)
Large ice
+
Clear ice (large size)
2
Select “ON”.
3
Finalize the setting.
4
Pull out the water tank and pour water
into it.
Do not tilt the water tank
when carrying as the water
may spill.
5
Set the water tank.
Securely insert the water tank. Ice
cubes will not be made unless the
tank is inserted fully.
NOTE
It takes about 24 hours to make the rst set of ice cubes.
For hygienic reasons, replace the water once a week even when
there is water remaining in the tank.
When you leave the tank empty it may sometimes make a
groaning noise but this is normal.
+
Tank is full at this
position.
Ice is made automatically.
Ice making process indication
Ice cube process indication will change according to the
completion of the ice making as follows.
Indication Condition
Automatic ice making is not operating.
Within 5 minutes after the water supply.
Ice making is started.
About two-thirds of the ice making is
complete.
When the ice storage box is full.
Ice making is nished. The ice cubes are
dropped to the ice storage box.
(Control panel will light up to show the
completion.)
Water tank is out of water. Pour water into
the water tank.
Even if the water tank is empty, the
ashing will be turned off by opening and
closing the refrigerator doors. However, the
ashing will restart after a short time.
NOTE
Do not use other than potable water. Do not use hot water (heat-
resistance:60°C), juice, tea, soda and sports drink etc.(Dirtying of
interior may result.) Malfunction of the ice maker may occur as a
result.
Large size ice may not be made when the water level of the water
tank is low even if large ice mode is selected.
Do not place the shovel or food on top of the ice cubes. This may
cause the automatic ice maker to malfunction (damage of the
detection lever, etc.) or the case not being able to be pulled out.
Set the shovel at the designated location.
Protrusions of ice cubes
There are some slits placed in the
ice tray. Therefore, the ice cubes
coming from the tray will have
protrusions from these slits.
The protrusions may be pointed.
Be careful when putting the ice
cube directly in your mouth.
White in ice cubes and oating substance
The minerals contained in water may solidify and whiten as
water freezes. Minerals turn into a state which is insoluble in
water once it freezes, so melting the ice cubes will leave only
white oating substances, but this is normal.
This is more likely to happen when you use hard water
(e.g.The hardness of the water is 100mg/L or more).
The same thing will happen even if clear ice is set “ON”.
(Flashing)
Detection lever
Slit
Ice tray
Protrusion
Flashing
(B423)W_1.indb 15(B423)W_1.indb 15 2013/04/18 18:24:412013/04/18 18:24:41
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sharp SJ-FS820V wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info