Bedienungsanleitung Sharp TM200 (Seite 9 von 176) (Deutsch)

679525

Zoom out

Zoom in

Vorherige Seite

1/176

Nächste Seite

1-9

Einleitung

3 Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

4 Consult the dealer or an experienced radio/TV

technician for help.

CAUTION: Changes or modifications not expressly

approved by the manufacturer responsible for

compliance could void the user’s authority to

operate the equipment.

Exposure to Radio Waves

THIS MODEL PHONE MEETS THE GOVERNMENT’S

REQUIREMENTS FOR EXPOSURE TO RADIO

WAVES.

Your wireless phone is a radio transmitter and receiver. It

is designed and manufactured not to exceed the emission

limits for exposure to radio frequency (RF) energy set by

the Federal Communications Commission of the U.S.

Government. These limits are part of comprehensive

guidelines and establish permitted level of RF energy for

the general population.

The guidelines are based on standards that were

developed by independent scientific organizations

through periodic and thorough evaluation of scientific

studies. The standards include a substantial safety

margin designed to assure the safety of all persons,

regardless of age and health. The exposure standard for

wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, SAR. The SAR

limit set by the FCC is 1.6W/kg, * Tests for SAR are

conducted using standard operating positions specified

by the FCC with the phone transmitting at its highest

certified power level in all tested frequency bands.

Although the SAR is determined at the highest certified

power level, the actual SAR level of the phone while

operating can be well below the maximum value. This is

because the phone is designed to operate at multiple

power levels so as to use only the power required to reach

the network. In general, the closer you are to a wireless

base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it

must be tested and certified to the FCC that it does not

exceed the limit established by the government-adopted

requirement for safe exposure. The tests are performed in

positions and locations (e.g., at the ear and worn on the

body) as required by FCC for each model. The highest

SAR value for this model phone when tested for use at the

ear is 0.631W/kg and when worn on the body, as

described in this operation manual is 1.42W/kg.

Body-worn Operation; This device has been tested for

typical body-worn operations with the back of the phone

touching the body. Body-worn operations are restricted to

belt-clips, holsters or similar accessories that have no

metallic component in the assembly. The use of

accessories that do not satisfy these requirements may

not comply with FCC RF exposure requirements, and

should be avoided. While these may be differences

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp TM200 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sharp TM200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info