469889
87
Zoom out
Zoom in
Vorherige Seite
1/92
Nächste Seite
83
Appendix
Problem Check Page
3D images fl icker when
watching in a room.
Images may appear to fl icker when fl uorescent light or ambient light
enters your vision.
Turn off the lights.
Block any ambient light.
Ghosting (a double image)
occurs without the image
appearing in 3D.
Check that you are using 3D LCD shutter glasses that support the
DLP
®
Link system.
Be sure to use 3D LCD shutter glasses that support the DLP
®
Link
system.
Check that the shutters on the 3D LCD shutter glasses are working
properly.
Turn the 3D LCD shutter glasses off and then on again.
Check the batteries of the 3D LCD shutter glasses.
Check that the 3D LCD shutter glasses are set to 3D viewing mode.
Some 3D LCD shutter glasses are equipped with a special viewing
mode (such as “dual view mode”) in addition to the normal 3D
viewing mode. See the operation manual of your 3D LCD shutter
glasses.
Check the settings of the projector.
Turn the DLP
®
Link™ function “On”.
Use “DLP
®
Link™ Invert” to change the setting.
Check whether a signal that is not supported is being input.
Confi gure your 3D application at the correct resolution and refresh
rate.
Make sure you are running your 3D application in resolutions that
support 3D. To support 3D, your 3D application must be con gured
to run at the correct settings for this projector.
For details on the supported signals, see “3D Supported Signals” of
the Compatibility Chart.
76
If the projector is connected to a computer for 3D image playback,
check that a stereoscopically-enabled application is being used.
Use the applicable software.
Set the applicable software to the fi eld sequential format.
Check that there are no obstructions between the screen and the 3D
LCD shutter glasses.
Remove any obstructions.
Any obstructions may cause the glasses not to function properly
causing the lenses to fl icker or turn off. Do not place your hand or
other objects in front of the 3D control signal sensor on the glasses.
Check whether there is a source of high intensity lighting nearby.
Block the light or turn it off.
High intensity lighting can interfere with communication between the
3D LCD shutter glasses and the screen resulting in some fl icker.
Check whether two or more projectors are projecting 3D images at the
same time.
Use only one projector at a time.
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect
operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5
minutes.
87

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sharp XG-SV200X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sharp XG-SV200X

Sharp XG-SV200X Bedienungsanleitung - Deutsch - 92 seiten

Sharp XG-SV200X Kurzanleitung - Holländisch - 26 seiten

Sharp XG-SV200X Bedienungsanleitung - Holländisch - 92 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info