Bedienungsanleitung Sharp XL-HF151PHS (Seite 31 von 35) (Englisch)

480430

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

11/5/12 10_HF151PH_EN.fm

E-20 10

Enhancing your system

The connection lead is not included. Purchase a

commercially available lead as shown below.

Note:

To prevent noise interference, place the unit away from the

television.

●Do not turn the volume on to full at switch on and listen

to music at moderate levels. Excessive sound pressure

from earphones and headphones can cause hearing

loss.

●Before plugging in or unplugging the headphone,

reduce the volume.

●Be sure your headphone has a 3.5 mm (1/8") diameter

plug and impedance between 16 and 50 ohms. The

recommended impedance is 32 ohms.

●Plugging in the headphone disconnects the speakers

automatically. Adjust the volume using the VOLUME

control.

Troubleshooting chart

Many potential problems can be resolved by the owner

without calling a service technician.

If something is wrong with this product, check the following

before calling your authorised SHARP dealer or service

centre.

■Listening to the playback sounds of

portable audio player, etc.

1Use a connection lead to connect the portable audio

player etc. to the AUDIO IN socket. When using video

equipment, connect the audio output to this unit and the

video output to a television.

2Press the ON/STAND-BY button to turn the power on.

3Press the AUDIO/LINE (INPUT) button on the remote

control or FUNCTION button repeatedly on main unit to

select AUDIO IN function.

4Play the connected equipment. If volume level of the

connected device is too high, sound distortion may

occur. Should this happen, lower the volume of the

connected device. If volume level is too low, increase the

volume of the connected device.

■Headphones

Audio cable (not supplied)

Portable audio

player, etc.

■General

Symptom Possible cause

●The clock is not set

to the correct time.

●Did a power failure occur?

Reset the clock. (Refer

page 6)

●When a button is

pressed, the unit

does not respond.

●Set the unit to the power

stand-by mode and then

turn it back on.

●If the unit still malfunctions,

reset it. (Refer page 21)

●No sound is heard. ●Is the volume level set to

“Min”?

●Are the headphones

connected?

●Are the speaker wires

disconnected?

■CD player

Symptom Possible cause

●Playback does not

start.

●Playback stops in

the middle or is not

performed properly.

●Is the disc loaded upside

down?

●Does the disc satisfy the

standards?

●Is the disc distorted or

scratched?

●Playback sounds are

skipped, or stopped

in the middle of a

track.

●Is the unit located near

excessive vibrations?

●Is the disc very dirty?

●Has condensation formed

inside the unit?

■Remote control

Symptom Possible cause

●The remote control

does not operate.

●Is the AC power lead of the

unit plugged in?

●Is the battery polarity

correct?

●Are the batteries dead?

●Is the distance or angle

incorrect?

●Does the remote control

sensor receive strong

light?

■Tuner

Symptom Possible cause

●The radio makes

unusual noises

continuously.

●Is the unit placed near the

TV or computer?

●Is the FM aerial placed

properly? Move the aerial

away from the AC power

lead if it is located nearby.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp XL-HF151PHS Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sharp XL-HF151PHS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info