Operations
LISTENING TO A PROGRAM SOURCE
10
Before operation
In the standby mode, turn the power on.
1
Select the desired input source.
3
Switch the desired speakers on.
2
• Enter the standby mode.
• The STANDBY indicator lights up.
This means that the amplifier is not disconnected from
the AC mains and a small amount of current is
retained to support the memorized contents and
operation readiness.
• To switch the power off, push the POWER switch
again, then the power is cut off and the STANDBY
indicator goes off.
• Then the corresponding SPEAKER indicator lights up
and the sound can be heard the speakers connected
to "SPEAKER A" or (and) "SPEAKER B" terminals.
• When using headphones for private listening, press
both SPEAKER SELECTOR A and B buttons to switch
the speakers off.
Note : For safe amplifier operation, be sure to check
impedance of the speakers connected. (Refer to
“CONNECTING SPEAKERS” on page 6)
• Then the corresponding indicator lights up.
• When the TAPE 2 MONITOR button is set to on so that
the TAPE 2 MONITOR indicator lights up, other inputs
can not be heard from the speakers.
To listen to a input source other than TAPE 2
MONITOR, be sure to set the TAPE 2 MONITOR
button to off.
TAPE MONITOR function
You can connect either a tape deck or a graphic
equalizer to the amplifier’s TAPE 2 MONITOR jacks.
Only when you listen to the component connected to
these jacks, set the TAPE 2 MONITOR button to on.
If you connect a 3-head tape deck, you can listen to the
sound being recorded during recording, not the source
sound.
For further details, refer to the operating instructions of
the component connected.
• Each time the POWER button on the remote control
is pressed, the amplifier is turned on to enter the
operating mode or off to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the amplifier is turned on
automatically and the desired input is selected.
SYSTEM POWER ON/OFF
• If the POWER switch of Sherwood component
connected by the DIGI LINK II or III is kept pushed
and its AC input cord is plugged in the switched AC
outlet, each time the amplifier becomes the standby
or the operating mode, its power is turned off or on.
• Under the same conditions, if its AC input cord is not
plugged only in the switched AC outlet, when the
amplifier becomes the standby mode, only its display
is off (meaning that a small amount of current is
retained for operation readiness, etc.)
or
or
ENGLISH
