23
The hours will advance when switch
“A” is pressed. If switch “A” is
pressed continuously, the hours will
advance rapidly. Press switch “B”
once to set the hour.
The minutes section will then start
flashing as shown in Fig 15.
Set the minutes in the same
procedure as for setting the hours.
The clock will then start.
Note; To reset clock
Fig.14
Fig.15
[]
Example
If the time is 10:46:23
• • • • • 10:47: - -
If the time is 13:59:16
• • • • • 14:00: - -
Get a display where CLK appears on the sub - display. Press switch
“B” for 5 seconds or more to change the time setting.
(
7
)
Setting the time
(
24 hour format
)
The display will change to that
shown in fig 14.
Set the time to one minute later than
the current time.
This completes the data entry operations. The display will now return to
the normal display mode.
Insert the battery so that the “+”
side is visible as shown in Fig. 16,
and then tighten the battery cap.
The battery which is installed at the
time of purchase is for monitoring
purposes. If the low
battery indicator appears, replace
the battery as soon as possible.
Carry out the initialization
procedure after the battery has
been replaced.
Replacing the battery (CR-2032 battery)
Close
Open
Fig.16
CR-2032
