668266
11
Zoom out
Zoom in
Vorherige Seite
1/22
Nächste Seite
5
Installation
17 Connect in accordance with the
terminal diagram.
18 Wiring diagram with CTÖ 602-0.
19 For each call button, a maximum
of two in-house telephones can be
connected. Connection of a storey
call button (ERT) is only possible
with the storey call button accessory
ZERT811-…
Terminal assignment CA812-…
1, 7… System line 1+n
b, c Power supply 12VAC
Relay contact door release
Li Relay contact light
D+, D- CTÖ602-…/SFC602-…
control
Terminal assignment TR 603-…
b, c Power supply 12VAC
L1, N Power connection
Terminal assignment HTS811-…
1, 7 System line 1+n
ERT Storey call button
Range
Range from the transformer to the
door station max. 50m, transformer
to the in-house telephone 400m
with 0.8mm conductor material.
When operating 2 in-house tele-
phones in parallel, the range reduces
to 200m.
*) Using the light button in the in-
house telephones HTS811-… the
light contact in the door loudspeaker
is closed for 0.8 seconds. The refer-
ence for this contact is terminal c,
pick-off at terminal Li. Following
completion of the installation, this
function is active without any further
programming. To actuate the stair-
case and/or outside light, according
to VDE regulations a light current
relay or time relay (e.g. ZR502-…)
must be interconnected. Contact
load max. 15VAC, 30VDC,
switching time 0.8 seconds.
In parallel to an in-house telephone,
the secondary signal controller
NSC602-… can be connected, e.g.
for actuation of a radio chime. The
NS711-… can be operated as an
additional signalling unit in parallel
at an HTS811-…
It is not possible to connect other
devices such as a DCA612-… or
HTC811-…
Lettering
20 Open the nameplate from the
outside, for example using a at
bladed screwdriver, and carefully
remove the inscription insert. To
insert the nameplate, lock into place
by exerting light pressure.
21 Info sign from the inside, e.g.
open using at blade screwdriver
and remove inscription eld. To
insert, clip in the info sign exerting a
slight pressure.
Troubleshooting
The transformer is tted with a
thermal fuse on the primary side.
After short circuit or overload
• Disconnect the device from the
power supply for appr. 1 min.
• Remedy the fault.
• Restore the mains power.
Specications CA812-…
Contact type: n.o. contact 24V, 2A
Protection system: IP54
Ambient temperature:
–20°Cto+55°C
Dimensions (mm) WxHxD:
82x226x33
Specications TR603-…
Operating voltage: 230VAC,
+/-10%, 50/60Hz
Output voltage: 12VAC
Output current: max.1.3A
Fusing:
Secondary side with thermal fuse
Protection system: IP30
Ambient temperature:
0°Cto+40°C
Horizontal pitch (HP): 3
Dimensions (mm) WxHxD:
53.5x89x60
Specications HTS811-…
Dimensions (mm) WxHxD:
91x201x46
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siedle SET CA 812-4 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info