Bedienungsanleitung Siemens C455 (Seite 9 von 41) (Englisch)

67282

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

Gigaset C 455 / ¢ / A31008-M1707-R101-1-UZ19 / starting.fm / 27.7.07

First Steps

Setting up the handset for use

Inserting the batteries

¤ Fit the batteries with the correct polarity

(see diagram).

The polarity is indicated in the battery compart-

ment.

The handset switches on automatically. You will

hear a confirmation tone.

Closing the battery cover

¤ Position the cover pointing slightly down-

wards and push it up until it clicks into posi-

tion.

Opening the battery cover

¤ Press below the upper curve on the battery

cover and slide down.

Placing the handset in the base station

and registering

Important: the handset must not already be

registered to a base station.

Registering the handset to the Gigaset C455

base station occurs automatically.

¤ Place the handset in the charging cradle of

the base unit with its display facing for-

ward.

You will hear a confirmation tone.

Automatic registration takes around one

minute. While registration is in progress the

screen displays Registering and Base flashes.

The handset is assigned the lowest unassigned

internal number (1–4). If several handsets are

registered to the base, the internal number is

shown in the display after registration, e.g. INT

2. This means that the handset has been

assigned the internal number 2. If the handset

has been registered successfully you will see

the display key

§INT§ at the bottom left of the dis-

play.

¤ To charge the batteries, leave the handset in

the charging cradle on the base station.

For questions and problems see page 30.

Caution:

Use only the rechargeable batteries recommended by

Siemens on page 32. I.e. never use a conventional

(non-rechargeable) battery or other battery type,

otherwise serious damage to health and property

cannot be ruled out, e.g. the outer casing of the bat-

teries could be destroyed or the batteries could

explode. The phone could also malfunction or be

damaged as a result of using batteries that are not of

the recommended type.

Notes:

– Automatic registration is not possible when the

base station on which you wish to register the

handset is being used to make a call.

– A key press cancels automatic registration.

– If four handsets are already registered to the base

station there are two options:

– The handset with the internal number 4 is in

idle status: the handset you wish to register is

assigned the number 4. The handset that was

previously number 4 is de-registered.

– The handset with the internal number 4 is

being used: the handset you wish to register

cannot be registered.

– If automatic registration does not work the hand-

set will have to be registered manually (page 24).

Notes:

– The handset may only be placed in the base pro-

vided for it.

– If the handset has switched itself off because the

batteries are flat and is then placed in the cradle,

it will switch itself on automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens C455 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens C455

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info