Bedienungsanleitung Siemens EH875SP17E (Seite 9 von 16) (Englisch)

527389

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Flexible zone

This may be used as a single zone or two individual zones

depending on the cooking needs in each situation.

It consists of 4 independently-controlled inductors. When the

flexible zone is working, only the zone covered by the cookware

is activated.

Advice on using cookware

To ensure that the cookware is detected and heat is distributed

evenly, correctly centre the cookware:

Warnings

When using cookware of a different size or made of a different

material, noise and vibrations that do not affect the correct

working of the zone may occur.

Consisting of two independent zones

The flexible zone can be used normally as two independent

hotplates.

How to activate

See “adjusting the hotplate“ section.

As one hotplate

To use the entire hotplate with all individual zones.

How to activate

The hob must be switched on.

1. Place the pan and select the desired hotplate by pressing its

programming zone.

2. Press the þ symbol. The þ indicator lights up.

The flexible zone has been activated.

3. Now select the desired power level by sliding your finger over

the corresponding programming zone for one of the two

hotplates that form part of the flexible hotplate.

The power level lights up on the indicators for both hotplates.

The flexible zone is switched on.

Changing the power level

Change the power level by sliding your finger over one of the

two programming zones.

Adding more cookware

Press the

þ symbol. The ê indicator lights up during the

search and detection of new cookware. The new pan will be

detected and the previously selected power level will be

maintained.

Note: If the pan on the hotplate that is switched on is moved or

removed, the hob will perform an automatic search and the

previously selected power level will be maintained.

To deactivate

Set it to

‹ in the programming zone.

Return to using two hotplates

Select one of the two hotplates of the flexible zone and set to

‹.

Note: When a hob is switched off and later switched on again,

the flexible zone will again be used as two hotplates.

As one hotplate

Diameter less than or equal to 13 cm

Place the cookware on one of the four posi-

tions shown in the image.

Diameter greater than 13 cm

Place the cookware on one of the three

positions shown in the image.

If the cookware takes up more than one hot-

plate, place it at the top or bottom edge of

the flexible zone.

As two independent hotplates

The front and back hotplates, each with two

inductors, can be used independently by

selecting the necessary power for each

one. In this case, it is recommended to only

use one pan on each hotplate.

To obtain maximum power with the

Powerboost Function, place the

cookware in the centre of the flexi-

ble zone when used as a single hot-

plate.

On hobs with more than one flexible

zone, it is not recommended to use

several zones at the same time for a

single pan.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens EH875SP17E Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens EH875SP17E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info