en Hood control
42
Connecting via your home network
You require a router that has WPS functionality.
Access to your router is required. If you do not have
this, follow the steps listed under "Direct connection".
When you begin, make sure that the extractor hood is
connected to the same home network.
1. Touch the ® symbol in the docking menu to open
the basic settings.
2. Select the Hood control cookConnect hood control
setting.
3. Touch "Connect to network".
4. Press the WPS button on the router within the next
2 minutes.
A message will be displayed to notify you when the
hob is successfully connected to your home
network.
5. You have 2 minutes to initiate the connection
process on the extractor hood.
A message is displayed to notify you when the hob is
successfully connected to the extractor hood. The
symbols for the hood controls on the hob are displayed
on the main screen.
Note:
Connection can only be established when both
appliances are connected to your home network and
the connection process has been initiated for both of
them. If the time allowed for connecting has already
expired for one of the two appliances, initiate the
connection process again.
Disconnecting from the network
Di s connec t i ng f r om t he net wor k
You can reset the connections you have saved for your
home network and extractor hood at any time.
1. Touch the e symbol in the docking menu to open
the basic settings.
2. Touch the "Hood control" setting.
3. Touch "Disconnect".
The connection has been restored.
Control the hood via the hob
In the basic settings of your hob you can adjust the
behaviour of your extractor hood depending on the
switch-on/off of the hob or individual cooking zones.
~ "Hood control settings" on page 43
You can select other settings using the control panel.
Setting the fan
Activation
1. Touch the I symbol in the settings area.
The preset fan setting is shown on the display.
2. Select the fan setting you require.
Touch int 1 or int 2 to select one of the intensive
modes.
The fan has been activated.
Deactivating
1. Touch the I symbol in the settings area.
2. Select fan setting 0.
The fan has been deactivated.
Setting automatic mode
Activation
1. Touch the I symbol in the settings area.
2. Select !.
Automatic mode is activated.
The fan starts automatically when steam is produced.
Deactivating
1. Touch the I symbol in the settings area.
2. Select fan setting 0.
Automatic mode is deactivated.
Setting the hood lighting
The hood light can be switched on and off using the
control panel on the hob.
Touch the = symbol on the main screen.
needs at any time.
connected to an extractor hood.
depending on how you want the fan to run.
matic mode.
setting.
cally afterwards.
the hob.
