Bedienungsanleitung Siemens gigaset a160 duo (Seite 9 von 12) (Englisch)

298693

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Athen / IM-Nord-en / A31008-M1801-R201-2-9W19 / Athen_Kombi_en_neu.fm / 17.09.2008

Appendix

Entering special characters

Standard characters

Specifications

Recommended battery pack

(Valid at the time of going to press)

Nickel-metal-hydride (NiMH):

Handset A16: V30145-K1310-X383

Handset A26: V30145-K1310-X359, X402

The handset is supplied with the recommended

battery pack.

Base station power consumption

In standby mode: approx. 2W

During a call: approx. 3W

General specifications

Care

Wipe the base station, charging cradle and handset

with a damp cloth (do not use solvent) or an anti-

static cloth.

Never use a dry cloth. This can cause static.

Contact with liquid

If the handset has come into contact with liquid:

1 Switch off the handset and remove the bat-

tery pack immediately.

2 Allow the liquid to drain from the handset.

3 Pat all parts dry, then place the handset with

the battery compartment open and the keypad

facing down in a dry, warm place for at least

72 hours (not in a microwave, oven etc.).

4 Do not switch on the handset again until it is

completely dry.

When it has fully dried out, you will normally be

able to use it again.

Questions and answers

If you have any queries about the use of

your phone, you can contact us any time at

www.gigaset.com/customercare

The table below contains a list of common

problems and possible solutions.

Authorisation

This device is intended for analogue phone lines in

your network.

Country-specific requirements have been taken

into consideration.

We, Gigaset Communications GmbH, declare that

this device meets the essential requirements and

other relevant regulations laid down in Directive

1999/5/EC.

A copy of the 1999/5/EC Declaration of Conformity

is available at this Internet address:

www.gigaset.com/docs

1x 2x 3x 4x 5x 6x

1 Space 1 £ $ ¥ ¤

Q .,?!0+

P * / ( ) < =

Abc-->

123

123-->

abc

#@ \ &

DECT standard is supported

GAP standard is supported

Range up to 300 m outdoors,

up to 50 m in buildings

Base station power supply 230 V ~/50 Hz

Environmental conditions

in operation

+5 °C to +45 °C;

20% to 75% humidity

Problem Cause Solution

Nothing

appears in the

display.

The handset is not

switched on.

Battery pack is

flat.

Press the end call key

a for approx. 5 sec.

or place the handset

in the base station.

Charge/replace the

battery pack (page 3).

No reaction to

keystroke.

The key lock is

activated.

Press the hash key

for approx. 2 sec.

(page 1).

No wireless

connection to

the base sta-

tion, Base

flashes in the

display.

The handset is

outside the range

of the base

station.

The handset is not

registered.

The base station is

not switched on.

Cords not routed

correctly

Move the handset

closer to the base

station.

(page 3).

Check the power

connector at the base

station (page 2).

Check cord routing

(page 2).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens gigaset a160 duo Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens gigaset a160 duo

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info