63676
11
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
10
Installing the Gigaset HC450 door intercom system
Gigaset HC450 / en / A31008-M1799-R101-2-7619 / Starting.fm / 08.10.2008
Version 4, 16.09.2005
extended by means of a repeater
placed between the base station
and control unit.
u Mount the HC450 control unit at a suit-
able location along the junction wire
between the bell button and bell.
It is recommended that you mount the
unit near the bell transformer. This is
normally located in the fuse box. Any
adjustment required to the fuse box
must be undertaken by a qualified
electrician.
u To ensure that a suitable mounting
location is selected, familiarise yourself
with the location of the cabling before-
hand. Watch out for the cabling
between the bell button, the bell trans-
former and the bell. Lay the cables so
that nobody can walk on or trip over
them. Before finally mounting the
control unit, check the placement of
the unit with temporary cabling by per-
forming a function test (control unit
can register with the base station, sta-
ble operation possible with adequate
connection quality from the handset to
the HC450 door intercom).
u You should also refer to the mounting
instructions for the HC450 door inter-
com (see p. 7).
u The control unit must not be installed
in a fuse box or metal housing.
u The control unit must not be installed
near air conditioning systems, in areas
with strong sunlight or in dusty
environments.
u The control unit must be protected
from the direct influence of water
and chemicals.
u Areas with strong magnetic fields
(transformers, electric motors, high-
voltage lines) must be avoided.
u Cables must not be connected or dis-
connected or the HC450 control unit
installed during a thunderstorm.
u Watch out for electrical, water or gas
lines in the wall if mounting the control
unit on the wall.
Mounting
If necessary, loosen the screws from the
casing. Pull the cover downwards to
remove it.
Mark the positions of the two drill holes on
the wall. Drill two holes suitable for 6 mm
wall plugs. Screw the upper screw into the
wall plug and mount the casing by fixing
the upper mounting hole onto the screw.
Screw the casing into place using the
lower mounting hole.
For laying the cables, a multi-core commu-
nications cable is recommended with a
wire profile of 0.6 mm.
Button
Mounting hole
Strain relief
Casing screw
LED
Mounting hole
Clip-on cover
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siemens Gigaset HC450 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Siemens Gigaset HC450

Siemens Gigaset HC450 Bedienungsanleitung - Deutsch - 32 seiten

Siemens Gigaset HC450 Bedienungsanleitung - Holländisch - 30 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info