Bedienungsanleitung Siemens HB64AA520F (Seite 9 von 24) (Englisch)

476345

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Automatic shut off

If the settings of the appliance are not changed for several

hours it is automatically shut off. The oven will stop heating.

This depends on the temperature or grill power selected.

Automatic shut off is activated

A signal will sound. The display shows

”‰. The oven will stop

heating.

Turn the function control knob to the zero setting. The oven

switches off.

Cancelling the automatic shut off function

To avoid triggering the automatic shut off, a cooking time must

be set. The oven will heat until this time is up.

Self-cleaning

During the self-cleaning function, the oven heats to about

500 °C. In this way, baking and cooking remains are burned

and only ash remains have to be cleaned from the oven.

There are three cleaning levels available.

The more intense and old the dirt, the higher the self cleaning

level used. The inside of the oven only has to be cleaned once

every two or three months. Complete cleaning requires

approximately 2.5 - 4.7 kilowatt-hours.

Suggestions and warnings

For safety reasons, the oven door locks automatically. The oven

door can be opened once again when the inside of the oven

has cooled a little and the lock symbol switches off. Do not

attempt to move the latch by hand.

Do not attempt to open the oven door during self-cleaning.

Otherwise, cleaning will be interrupted.

The oven light does not switch on during self-cleaning.

ã=Risk of fire!!

The outside of the oven heats up considerably. Keep the front

of the oven clear. Do not place flammable objects, such as

dishcloths, on the door handle. Keep children away.

Before using the self-clean function

The oven must be empty. Remove all pans and unsuitable

accessories from inside the oven.

Clean the oven door and the side surfaces inside the oven

around the area with seals. Do not rub the seals.

ã=Risk of fire!!

The remains of food and grease as well as roasting juices can

catch fire. Use a damp cloth to clean the inside of the oven and

the accessories that will be cleaned inside the oven.

Cleaning of the accessories

For optimum cleaning of the oven interior, it is recommended

that the self-clean function is not used with the trays.

However, the universal deep enamel tray or the flat enamel

oven tray can only be cleaned using the self-clean function on

level 2.

The shelf should not be cleaned using the self-clean function.

Use water to clean food remains, oil and roasting juices from

the accessories.

ã=Significant health risks!

Do not place non-stick baking tins or trays in the oven during

self-cleaning. The intense heat removes the non-stick surface

and creates toxic gases.

Setting

Once the cleaning level has been selected, set the oven.

1.Select the Self-cleaning x function with the function control

knob.

2.Set the required cleaning level using the @ or A sensors.

The display panel will show the cleaning level and the

x symbol. Self-cleaning starts within a few seconds.

The oven door locks shortly after the function has started. The

H symbol lights up on the display panel. Only when the

H symbol turns off can the oven door be opened again.

Self-cleaning has ended.

The display panel will show

‹‹:‹‹. The oven will stop heating.

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

H symbol on the display panel turns off.

Changing the cleaning level

The cleaning level cannot be changed once it has started.

Stopping the self-cleaning

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

H symbol on the display panel turns off.

Delaying the end time

The oven allows you to programme the self-cleaning end time.

Self-cleaning can therefore be programmed at night for

example, leaving the oven free for use during the day.

Programme as described in section 1 and 2. Before starting the

self-cleaning, press the

0 sensor three times and delay the

end time with the

@ or A sensors.

The oven is set to standby. The display panel will show the

cleaning level and the

y symbol. When self-cleaning starts, the

cleaning level and the

x symbol are shown. The y symbol

switches off.

Viewing the time settings

To view the duration of the cleaning level or the end time of the

self-cleaning press the

0 sensor repeatedly until the required

symbol lights up. The corresponding value will be shown for a

few seconds on the display panel.

After using the self-clean function

Once the inside of the oven has cooled, clean the ash remains

using a damp cloth.

Level Cleaning level Duration

‚

mild approx. 1 hour, 15 minutes

medium approx. 1 hour, 30 minutes

„

intense approx. 2 hours

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens HB64AA520F Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens HB64AA520F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info