Bedienungsanleitung Siemens HB74AS550E (Seite 10 von 24) (Englisch)

644503

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

ã=Risk of fire!!

The remains of food and grease as well as roasting juices can

catch fire. Use a damp cloth to clean the inside of the oven and

the accessories that will be cleaned inside the oven.

Cleaning of the accessories

The wire shelves or left and right hand side rails are not

suitable for self cleaning. Remove these from the oven.

For optimum cleaning of the oven interior, it is recommended

that the self-clean function is not used with the trays. However,

with the accessory support, the universal deep enamel tray or

the flat enamel oven tray can also be cleaned using the self-

clean function. Only clean one accessory at a time.

The shelf should not be cleaned using the self-clean function.

If your oven does not have this support, it can be purchased

from the Technical Assistance Service or over the Internet by

quoting part number 466546.

The accessory support is inserted to the right and left.

Use water to clean food remains, oil and roasting juices from

the accessories.

Place the universal deep tray or the flat oven tray on the

support.

ã=Significant health risks!

Do not place non-stick baking tins or trays in the oven during

self-cleaning. The intense heat removes the non-stick surface

and creates toxic gases.

Setting

Once the cleaning level has been selected, set the oven.

1. Select the Self-cleaning x function with the function control

knob.

2. Set the required cleaning level using the @ or A sensors.

The display panel will show the cleaning level and the

x symbol. Self-cleaning starts within a few seconds.

The oven door locks shortly after the function has started. The

H symbol lights up on the display panel. Only when the

H symbol turns off can the oven door be opened again.

Self-cleaning has ended.

The display panel will show

‹‹:‹‹. The oven will stop heating.

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

H symbol on the display panel turns off.

Changing the cleaning level

The cleaning level cannot be changed once it has started.

Stopping the self-cleaning

Turn the function control knob to the zero setting. The oven

switches off. The oven door can be opened again when the

H symbol on the display panel turns off.

Delaying the end time

The oven allows you to programme the self-cleaning end time.

Self-cleaning can therefore be programmed at night for

example, leaving the oven free for use during the day.

Programme as described in section 1 and 2. Before starting the

self-cleaning, press the

0 sensor three times and delay the

end time with the

@ or A sensors.

The oven is set to standby. The display panel will show the

cleaning level and the

y symbol. When self-cleaning starts, the

cleaning level and the x symbol are shown. The y symbol

switches off.

Viewing the time settings

To view the duration of the cleaning level or the end time of the

self-cleaning press the

0 sensor repeatedly until the required

symbol lights up. The corresponding value will be shown for a

few seconds on the display panel.

After using the self-clean function

Once the inside of the oven has cooled, clean the ash remains

using a damp cloth.

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright

appearance and operating performance for many years to

come. Advice on how to care for and clean your oven is

provided below.

Notes

■ Different colours may be seen in your front panel due to the

various materials used in its manufacture, such as glass,

plastic and metal.

■ Dark patches in the door's glass panel may seem to be dirt

but they are in fact reflections from the oven light.

■ Enamel burns at very high temperatures. This may cause

slight discolouration. This is normal and does not affect the

oven's operation. The edges of thin baking trays may not be

completely enamelled. They may therefore feel slightly rough,

although their corrosive protection will be unaffected.

Cleaning products

Follow the information provided in the table to avoid damaging

the various oven surfaces by using unsuitable cleaning

products. Do not use

■ abrasive or acidic cleaning products,

■ strong products containing alcohol,

■ scourers or hard sponges,

■ high-pressure or steam cleaners.

Wash new cloths thoroughly before use.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens HB74AS550E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens HB74AS550E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info