Bedienungsanleitung Siemens HR745226N (Seite 7 von 56) (Englisch, Holländisch)

529983

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Set-up, gas and electricity connection

Gas connection

Installation must only be performed by an approved expert or a

licensed after-sales service engineer in accordance with the

instructions specified under "Gas connection and conversion to

a different gas type".

For the licensed expert or after-sales service

Caution!

■ The setting conditions for this appliance are specified on the

rating plate on the back of the appliance. The gas type set in

the factory is marked with an asterisk (*).

■ Before setting up the appliance, check the grid access

conditions (gas type and gas pressure) and ensure that the

gas setting of the appliance meets these conditions. If the

appliance settings have to be changed, follow the instructions

in the section "Gas connection and conversion to a different

gas type".

■ This appliance is not connected to a waste gas main. It must

be connected and commissioned in accordance with the

installation conditions. Do not connect the appliance to a

waste gas main. All ventilation regulations must be observed.

■ The gas connection must be made via a fixed, i.e. not mobile

connection (gas line) or via a safety hose.

■ If using the safety hose, ensure that the hose is not trapped

or crushed. The hose must not come into contact with hot

surfaces.

■ The gas line (gas pipe or safety hose) can be connected to

the right or left-hand side of the appliance. The connection

must have an easily accessible locking device.

Faults in the gas installation/smell of gas

If you notice a smell of gas or faults in the gas installation, you

must

■ immediately shut off the gas supply and/or close the gas

cylinder valve

■ immediately extinguish all naked flames and cigarettes

■ switch off electrical appliances and lights

■ open windows and ventilate the room

■ call the aftersales service or the gas supplier

Moving the appliance by the gas line or door

handle

Do not move the appliance while holding the gas line; the gas

pipe could be damaged. There is a risk of a gas leak! Do not

move the appliance while holding it by the door handle. The

door hinges and door handle could be damaged.

Electrical connection

Caution!

■ Have the appliance set up by your after-sales service. A 16 A

fuse is required for connection. The appliance is designed for

operation at 220-240 V.

■ If the electricity supply drops below 180 V, the electrical

ignition system does not work.

■ Any damage arising from the appliance being connected

incorrectly will invalidate the guarantee.

■ If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons

in order to avoid a hazard.

For the after-sales service

Caution!

■ The appliance must be connected in accordance with the

data on the rating plate.

■ Only connect the appliance to an electrical connection that

meets the applicable provisions. The socket must be easily

accessible so that you can disconnect the appliance from the

electricity supply if necessary.

■ Please ensure the availability of a multi-pin disconnecting

system.

■ Never use extension cables or multiple plugs.

■ For safety reasons, this appliance must only be connected to

an earthed connection. If the safety earth terminal does not

comply with regulations, safety against electrical hazards is

not guaranteed.

■ You must use a H 05 W-F type cable or equivalent for the

appliance connection.

Levelling the cooker

Always place the cooker directly on the floor.

1. Pull out the plinth drawer and lift it up and out.

There are adjustable feet at the front and rear on the inside of

the plinth.

2. Use an Allen key to raise or lower the adjustable feet as

necessary until the cooker is level (picture A).

3. Push the plinth drawer back in (picture B).

Wall fixing

To prevent the cooker from tipping over, you must fix it to the

wall using the enclosed bracket. Please observe the installation

instructions for fixing the oven to the wall.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens HR745226N Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info