15
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
E-Nr. FD
If you encounter a problem
ṇ Old appliances are not worthless
rubbish. Valuable raw materials can be
reclaimed by recycling old appliances.
Before disposing of your old appliance, ren-
der it unusable.
ṇ You received your new appliance in a
protective shipping carton. All packaging
materials are environmentally friendly and
recyclable. Please contribute to a better
environment by disposing of packaging
materials in an environmentally-friendly
manner.
Please ask your dealer or inquire at your
local authority about current means of
disposal.
ṇ The extractor hood can be used in
exhaust air or circulating air mode.
ṇ Always mount the extractor hood over
the centre of the hob.
ṇ Minimum distance between electric hob
and bottom edge of extractor hood:
650 mm.
ṇThe extractor hood must not be
installed over a solid fuel cooker – a
potential fire hazard (e.g. flying sparks) –
unless the cooker features a closed,
non-removable cover and all national
regulations are observed.
ṇ The smaller the gap between the
extractor hood and hotplates, the greater
the likelihood that droplets will form on the
underside of the extractor hood.
Additional information concerning gas
cookers:
ṇ When installing gas hotplates, comply
with the relevant national statutory
regulations (e.g. in Germany: Technische
Regeln Gasinstallation TRGI).
ṇ Always comply with the currently valid
regulations and installation instructions sup-
plied by the gas appliance
manufacturer.
ṇ Only one side of the extractor hood may
be installed next to a high-sided unit or high
wall. Gap at least 50 mm.
ṇ Minimum distance on gas hotplates
between the upper edge of the trivet
and lower edge of the extractor
hood: 650 mm.
