Bedienungsanleitung Siemens LR97CAQ50 (Seite 19 von 24) (Englisch)

788770

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Installation instructions en

¡To optimally detect the cooking vapours, install the

appliance in the middle of the hob.

16.6 Instructions for the exhaust air pipe

The appliance manufacturer does not provide any war-

ranty for faults attributable to the pipeline.

¡Use a short, straight exhaust air pipe with as large a

pipe diameter as possible.

¡Long, rough exhaust air pipes, many pipe bends or

small pipe diameters reduce the suction power and

increase the fan noise.

¡Use an exhaust pipe that is made of non-combust-

ible material.

¡To prevent condensate from returning, fit the ex-

haust pipe with a 1° gradient from the appliance.

Flat ducts

Use flat ducts with an inner cross-section that corres-

ponds to the diameter of the round pipes:

¡Diameter of 150mm corresponds to ap-

prox.177cm².

¡Diameter of 120mm corresponds to ap-

prox.113cm².

¡Use sealing strips for different pipe diameters.

¡Do not use any flat ducts with sharp bends.

Round pipes

Use round pipes with an inner diameter of 150mm (re-

commended) or at least 120mm.

16.7 Instructions for the electrical

connection

In order to safely connect the appliance to the elec-

trical system, follow these instructions.

WARNING‒Risk of electric shock!

It must always be possible to disconnect the appliance

from the electricity supply. The appliance must only be

connected to a protective contact socket that has been

correctly installed.

▶The mains plug for the mains power cable must be

easily accessible after the appliance is installed.

▶If this is not possible, an all-pole isolating switch

must be integrated into the permanent electrical in-

stallation according to the conditions of overvoltage

category III and according to the installation regula-

tions.

▶The permanent electrical installation must only be

wired by a professional electrician. We recommend

installing a residual-current circuit breaker (RCCB)

in the appliance's power supply circuit.

Sharp-edged components inside the appliance may

damage the connecting cable.

▶Do not kink or trap the connecting cable.

¡The connection data can be found on the rating

plate. →Page14

¡The connecting cable is approx.1.30m long.

¡This appliance complies with the EC interference

suppression regulations.

¡The appliance corresponds to protection class 1.

You should therefore only use the appliance with a

protective earth connection.

¡Do not connect the appliance to the power supply

during installation.

¡Only a licensed professional may connect appli-

ances without plugs. They are subject to the require-

ments of the local electricity provider.

16.8 General information

Follow these general instructions during the installation.

¡For the installation, observe the currently valid build-

ing regulations and the regulations of the local elec-

tricity and gas suppliers.

¡When discharging the exhaust air, the official and

legal regulations, such as the regional building

code., must be observed.

¡In order to freely access the appliance for servicing,

select an easy-to-reach installation site.

¡The surfaces of the appliance are sensitive. Avoid

damaging them during installation.

16.9 Installation

Preparing the ceiling

1. Ensure that the stability of the ceiling is guaranteed

after the cut-outs have been made.

2. Cover the hob to prevent damage.

3. Saw a cut-out into the ceiling.

4. Remove any shavings.

Preparing the appliance

WARNING‒Risk of injury!

Components inside the appliance may have sharp

edges.

▶Wear protective gloves.

1. Tilt the transport lock slightly upwards and carefully

pull it upwards and out at an angle.

2. Remove polystyrene residues from the interior of the

appliance.

3. Remove the grease filters.

To avoid causing damage, do not bend the grease

filters.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens LR97CAQ50 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens LR97CAQ50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info