134209
36
Zoom out
Zoom in
Vorherige Seite
1/159
Nächste Seite
The symbol disappears from the screen when
the water tank has been emptied and replaced
on the appliance properly.
Warning!
When you turn the appliance back on again
after emptying all of the water, do not forget
to replace the removable tank on the
appliance properly. Should you fail to do
so, the symbol will not disappear from the
screen and the appliance will not work.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period of
time is required in order to ensure correct
appliance operation.
Dehumidification
In this operation function, the appliance
reduces the humidity in the atmosphere. The
appliance purifies the air in the room at the
same time in order to create a pleasant
atmosphere.
Plug the appliance into the mains electricity
supply.
Fit the hot air expulsion tube outside as
indicated in “Preparing the appliance before
use“.
Lift the air director on the top of the
appliance.
There are two ways of expelling condensed
water: via the removable tank and in
continuous mode.
Dehumidification via the removable tank:
Check that the removable tank is fitted onto the
appliance properly and that the plug is fitted
onto the water drainage pipe to prevent water
from leaking onto the support surface.
• When the water in the removable tank reaches
a certain level, the appliance beeps twice. T h e
removable tank full symbol appears on the
screen at the same time to indicate that the
tank needs to be emptied. The appliance stops
working when this happens. The symbol also
appears and the appliance beeps when the
removable tank is not properly fitted into its
h o u s i n g .
In both events, it is necessary to extract the
tank and pour the water carefully down the
nearest drain.
Turn the appliance on by pressing the "On"
key .
Select the cooling function , (see
"Selecting the operation function").
Select the desired temperature, (see
"Selecting the temperature"). If the
appliance turns itself off automatically
because the desired temperature for the
room has been reached, it will not start
working again until ambient temperature
rises 2-3°C.
Select the operation speed, (see "Selecting
the speed").
During air conditioning, the condensed water
produced evaporates automatically and is
expelled outdoors together with the expelled
air through the hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water in
the appliance’s rear tank. When a certain level
the appliance beeps twice. The removable
tank full symbol appears on the screen at
the same time to indicate that the tank needs
to be emptied. The appliance stops working
when this happens. To empty the removable
tank, press the handle and remove the tank
carefully. Empty the water down the nearest
drain.
36
Instructions for Use
Fig. 17
Plug the appliance into the mains electricity
supply.
Lead the hot air expulsion tube outside,
(see "Preparing the appliance before use").
Check that the plug is fitted onto the water
drainage pipe to prevent water from leaking
onto the support surface.
Lift the air director on the top of the
appliance, Fig. 17.
36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siemens pa 0840 m wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info