Bedienungsanleitung Siemens REV17 (Seite 7 von 40) (Alle Sprachen)

462306

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

CE1G2203xx 02.02.2010 7/40

Code list

Function block Code Name Factory setting Your setting

00 Language English

01 Sensor calibration off

Basic settings

02 Switching differential 2-point

0.5°C

10 Illumination time 10 seconds

11 Background brightness 0

LCD settings

12 Contrast 0

Time zone

Deviation from time signal received from Frankfurt

(Central European Time CET) (refer to Note 1)

0 hours

31 Start of summer time (refer to Note 2) March 31 (31-03)

Clock settings

32 End of summer time (refer to Note 3) October 31 (31-10)

Note 1:

If the radio clock is not active or not present, this setting has no impact.

With the radio clock active, the time signal received from Frankfurt is shifted by the value set under code 30 (time zone).

Note 2:

If the radio clock is not active or not present, the time change always takes place at 02:00 on the Sunday before the set date.

With the radio clock active, the time change is shifted by the value set under code 30 (time zone).

Note 3:

If the radio clock is not active or not present, the time change always takes place at 03:00 on the Sunday before the set date.

With the radio clock active, the time change is shifted by the value set under code 30 (time zone).

3 Function check

a) Check the display. If there is no display, check the batteries

b) “Continuously Comfort mode“

, read the temperature

displayed

c) Set the temperature setpoint to a level above the displayed

room temperature (see operating instructions)

d) The relay and thus the actuating device must respond within 1

minute. Symbol

▲ appears on the display. If not:

• Check actuating device and wiring

• The room temperature is possibly higher than the adjusted

temperature setpoint

e) Set temperature setpoint of “Continuously Comfort mode“ to

the required level

f) Select the required operating mode

4 Reset

User-defined settings:

Press simultaneously

, and for 3 seconds:

All temperature and time settings of the slider positions are reset to

their default values (refer to section “Factory settings“ in the

operating instructions). The settings made on the expert level will

remain unchanged.

The clock starts at 12:00, the date on 01-01-08

(01 - January - 2008). During the reset time, all sectors of the

display are illuminated and can thus be checked.

All user-defined settings plus those made on the expert level:

Press simultaneously the DIP switch reset button,

and

for 5 seconds:

After this reset, all factory settings will be reloaded. This applies to

both the slider settings and the settings made on the expert level.

Notes

• The controller is classified as a device of software class A and

designed for use in environments with normal degree of

pollution

Indications pour le montage REV17..

1 Emplacement

• Le REV17... doit être monté dans la pièce de séjour principale

(montage mural Fig. B à E).

• Pour que la mesure de la température de l'air dans la pièce ne

soit pas faussée, monter l'appareil à un endroit à l'abri du

rayonnement solaire ou d'autres sources de chaleur ou de

froid.

min.

10 cm

2261Z03

2 Montage

• cf. Fig. A à E

3 Vérification du câblage

Les raccordements sont indiqués dans le chapitre "Schéma de

raccordement".

Remarque: ne pas utiliser de câble plat, uniquement du

câble plein ou du câble plat avec embouts

prémontés

4 Remarques

• Respecter les prescriptions locales pour les installations

électriques.

• Si des vannes thermostatiques sont installées dans la pièce de

référence, elles doivent être ouvertes au maximum

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens REV17 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens REV17

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info