en Operating the appliance
36
Changing start programme
You can change the “Start programme”
setting.
Tone volume
The end of the programme is indicated
by a buzzer. You can also change this
setting.
Button volume
When you are operating the dishwasher,
a signal sounds whenever a button is
pressed. You can control the volume of
the signal. If you do not like the button
volume, you can switch it off.
Child-proof lock *
Child-proof lock
* depending on the features of your
dishwasher
The dishwasher features an electronic
child-proof lock. The child-proof lock
protects children from potential hazards
which the dishwasher poses.
You can switch the child-proof lock on
or off. When the child-proof lock is on, it
is difficult to open the door.
Greeting
When you switch on the dishwasher, the
brand logo appears. You can switch off
the brand logo.
Factory setting
You can reset all settings to the factory
setting.
Switching the appliance on
1. Turn on tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
4. Press START button )2.
5. Close the door.
Programme sequence starts.
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
“Standard programme” which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Time preselection
You can delay the start of the
programme by up to 24 hours.
Depending on the setting of the time
display, the end of programme is
indicated with “Finish in” (for example
3h 25m) or “Finish at” (for example
15:20 hours).
1. Open the door.
2. Switch on ON/OFF switch (.
3. Selects programme 0.
4. Press time preselection button h.
5. Keep pressing the setting buttons + -
` until the displayed time
corresponds with your requirements.
