Bedienungsanleitung Siemens SX66 (Seite 169 von 179) (Englisch)

481944

169

Zoom out

Zoom in

Vorherige Seite

1/179

Nächste Seite

SX66 User Manual

168

SX66 User Manual

169

FCC Compliance

Statement

n FCC part 15, 22 and part 24

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions : (1) this device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired

operation.

n FCC ID : NM8 BLUEANGEL

n Statement according to FCC part

15.105

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is

no guarantee that interference will not occur

in a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference by

one or more of the following measures.

n Reorient or relocate the receiving

antenna.

n Increase the separation between the

equipment and receiver.

n Consult the dealer or an experienced radio/

TV technician for help.

n Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

n RF EXPOSURES

Tests for SAR are conducted using standard

operating positions specied by the FCC with

the phone transmitting at its highest certied

power level in all tested frequency bands.

Although the SAR is determined at the highest

certied power level, the actual SAR level of

the phone during operation can be well below

the maximum value. This is because the phone

is designed to operate at multiple power levels

so as to use only the power required to reach

the network. In general, the closer you are to

a wireless base station antenna, the lower the

power output.

Before a phone model is available for sale to the

public, it must be tested and certied to the FCC

that it does not exceed the limit established by

the government-adopted requirement for safe

exposure. The tests are performed in positions and

locations (e.g., at the ear and worn on the body) as

required by the FCC for each model. (Body-worn

measurements may differ among phone models,

depending upon available accessories and FCC

requirements). While there may be differences

between the SAR levels of various phones and at

various positions, they all meet the government

requirement for safe exposure.

For body worn operation, to maintain compliance

with FCC RF exposure guidelines, use only

Siemens. approved accessories. When carrying

the phone while it is on, use the specic Siemens.

supplied or approved carrying case, holster, or

other body-worn accessory.

Use of non Siemens. approved accessories may

violate FCC RF exposure guidelines and should

be avoided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens SX66 Seite 169

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info