Bedienungsanleitung Siemens tk 56001 56004 (Seite 17 von 106) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

362542

Zoom out

Zoom in

Vorherige Seite

1/106

Nächste Seite

Settings and displays

Setting the water hardness

It is important that the water hardness be

set correctly, so that the appliance indicates

accurately when the descaling programme

should be run. The factory setting is a water

hardness of 4. You can check the water

hardness using the enclosed test strip or by

asking your local water supplier.

Degree Water hardness

German (°dH) French (°fH)

1-7

8-15

16-23

24-30

1-13

14-27

28-42

43-54

●Determinethewaterhardnesswiththe

enclosed test strip.

e.g. Hardness = 2

●Switchtheapplianceto“eco” mode.

●Holddownthesteambuttonh for at

least 5 seconds. The number of service

buttons 4, 5, eco, h that light up

indicate the selected water hardness.

●Pressthesteambuttonh repeatedly

until the correct number of buttons is lit.

●Pressbuttoneco once. The selected

number of service buttons should light

upbriey;thisindicatesthatthedesired

water hardness setting has been saved

successfully.

Ifawaterlter(specialaccessory)isused,

the water hardness should be set to 1.

Note: If no button is pressed within 90

seconds, the appliance switches to stand-

by mode without saving the new settings.

In this case, the previous water hardness

setting is retained.

Thersttimealterisusedorafter

changingthelter,theapplianceneedsto

be cleaned.

●Fillthewatertankuptothe“0.5l”mark.

●Placeasuitablecontainer(approx.0.5

litres) under the nozzle 9.

●Turnthedial8 to g/h.

●Ifnowatercomesoutofnozzle9, turn

the dial back to ““O”..

●Fillthewatertankandwaterpipes(see

section “Switching on the appliance”).

Setting the time for switchover to “eco”

mode

The appliance can be programmed so that

it automatically switches to “eco” mode

after a certain time (from 10 minutes to 4

hours).

●Switchtheapplianceto“eco” mode.

●Holddownthe5 button for at least 5

seconds.

If 4 lights up,

= switchover after 10 minutes

If 4, 5 lights up,

= switchover after 30 minutes

If 4, 5, eco lights up,

= switchover after 2 hours

If 4, 5, eco, h lights up,

= switchover after 4 hours

●Pressthe5 button to set the required

time.

●Presstheeco button to save the setting.

Note: The factory setting is 10 minutes.

Adjusting the grinding unit

Sliding switch 16 adjusts the degree of

grinding,fromcoarsetone.

Warning

Adjust the grinding unit only while it is

running! Otherwise the appliance may be

damaged.

●Pressthecoffeedispensingbutton4.

●Whilethegrindingunitisrunning,move

the sliding switch 16 to the desired

position:thesmallerthedots,thenerthe

grind.

i The new setting will not become apparent

until the second or third cup is brewed.

Tip: For dark roast coffee beans, choose a

coarsergrind;forlightroastbeans,selecta

nergrind.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens tk 56001 56004 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info