Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-15
16-23
24-30
1-13
14-27
28-42
43-54
●Determinethewaterhardnesswiththe
enclosed test strip.
e.g. Hardness = 2
●Switchtheapplianceto“eco” mode.
●Holddownthesteambuttonh for at
least 5 seconds. The number of service
buttons 4, 5, eco, h that light up
indicate the selected water hardness.
●Pressthesteambuttonh repeatedly
until the correct number of buttons is lit.
●Pressbuttoneco once. The selected
number of service buttons should light
upbriey;thisindicatesthatthedesired
water hardness setting has been saved
successfully.
Ifawaterlter(specialaccessory)isused,
the water hardness should be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to stand-
by mode without saving the new settings.
In this case, the previous water hardness
setting is retained.
Thersttimealterisusedorafter
changingthelter,theapplianceneedsto
be cleaned.
●Fillthewatertankuptothe“0.5l”mark.
●Placeasuitablecontainer(approx.0.5
litres) under the nozzle 9.
●Turnthedial8 to g/h.
●Ifnowatercomesoutofnozzle9, turn
the dial back to ““O”..
●Fillthewatertankandwaterpipes(see
section “Switching on the appliance”).
Setting the time for switchover to “eco”
mode
The appliance can be programmed so that
it automatically switches to “eco” mode
after a certain time (from 10 minutes to 4
hours).
●Switchtheapplianceto“eco” mode.
●Holddownthe5 button for at least 5
seconds.
If 4 lights up,
= switchover after 10 minutes
If 4, 5 lights up,
= switchover after 30 minutes
If 4, 5, eco lights up,
= switchover after 2 hours
If 4, 5, eco, h lights up,
= switchover after 4 hours
●Pressthe5 button to set the required
time.
●Presstheeco button to save the setting.
Note: The factory setting is 10 minutes.
Adjusting the grinding unit
Sliding switch 16 adjusts the degree of
grinding,fromcoarsetone.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
●Pressthecoffeedispensingbutton4.
●Whilethegrindingunitisrunning,move
the sliding switch 16 to the desired
position:thesmallerthedots,thenerthe
grind.
i The new setting will not become apparent
until the second or third cup is brewed.
Tip: For dark roast coffee beans, choose a
coarsergrind;forlightroastbeans,selecta
nergrind.
