Bedienungsanleitung Siemens tk54f09 (Seite 17 von 93) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

361450

Zoom out

Zoom in

Vorherige Seite

1/93

Nächste Seite

6 Standby button a

Button a switches on the appliance or

switches it to stand-by mode. When button

a is pressed, the appliance heats up and

buttonaasheswhiletheapplianceheats

up and is rinsed. When the buttons 4, 5, a

and h light up and one, two or three beans

(depending on the setting) appear on the

display, the appliance is ready for operation.

The appliance will not be rinsed if:

– it was still warm when switched on, or

– coffee was not discharged before it was

switched to “stand-by“ mode,

– steam was discharged shortly before it

was switched off.

7 Steam generation button h

Button h generates steam for foaming or

warming.

8 Steam dispensing dial

Hot water or steam can be dispensed by

turning the dial to hot water g or steam h.

To dispense steam, the steam generation

button hmustbepressedrst(see“Steam

for foaming milk“).

Settings and displays

Setting the water hardness

It is important that the water hardness be

set correctly, so that the appliance indicates

accurately when the descaling programme

should be run. The factory setting is a water

hardness of 4. You can check the water

hardness using the enclosed test strip or by

asking your local water supplier.

Degree Water hardness

German (°dH) French (°fH)

1-7

8-15

16-23

24-30

1-13

14-27

28-42

43-54

●Determinethewaterhardnesswiththe

enclosed test strip.

e.g. = Hardness 2

●Switchthedevicetostandby.

●Holddownthesteambuttonh for at

least 3 seconds. The number of service

buttons 4, 5, a, h that light up indicate

the selected water hardness.

●Pressthesteambuttonh repeatedly

until the correct number of buttons is lit.

●Pressbuttona once. The selected

number of service buttons should light

upbriey;thisindicatesthatthedesired

water hardness setting has been saved

successfully.

Ifawaterlter(specialaccessory)isused,

the water hardness should be set to 1.

Note: If no button is pressed within 90

seconds, the appliance switches to stand-

by mode without saving the new settings.

In this case, the previous water hardness

setting is retained.

Thersttimealterisusedorafter

changingthelter,theapplianceneedsto

be cleaned.

●Fillthewatertankuptothe0.5lmark.

●Placeasuitablecontainer(approx.0.5

litres) under the nozzle 9.

●Turnthedial8 to g/h.

●Ifnowatercomesoutofnozzle9, turn

the dial back to O.

●Fillthewatertankandwaterpipes(see

section “Switching on the appliance”).

Adjusting the grinding unit

Sliding switch 16 adjusts the degree of

grinding,fromcoarsetone.

Warning

Adjust the grinding unit only while it is

running! Otherwise the appliance may be

damaged.

●Pressthecoffeedispensingbutton4.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens tk54f09 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info